[cisco-voip] Enterprise Feature Access with Two-Stage Dialing problem

[Jason Wydra]

CUCMBE 6.0(1)
MGCP 2811 IOS 12.4 (PRI)

I'm trying to enable Enterprise Feature Access with Two-Stage Dialing on a
newly installed CUCMBE 6.0(1). The instructions tell me to configure
mobility under the call routing section of the admin pages. I added in the
Enterrpise Feature Access Directory number and partition for the DID I'm
using but I don't know what to use for the handoff number field. It tells me
to plug in a number for wi-fi, GSM or CDMA?? It won't let me leave the field
blank. So, I put a dummy number in there just for kicks. When I call the DID
access number I get a recording from telco saying that the number is not a
working number. I know for a fact that the number works because if I assign
it to an IP phone it will ring the phone. The reason I am using Enterprise
Feature Access with Two-Stage Dialing instead of Mobile voice access is
because I don't want to have to switch my gateway to H323. I assume I'm
missing a step in the configuration. I have all of the services in
enterprise parameters turned on. Any help would be appreciated.

Thanks,
Jason
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20071127/8c63e100/attachment.html