[cisco-voip] Access Valcom Paging from FXO port

[Steve G]

Are you using h323 or MGCP to control the fxo port?

Do you see the green light on your FXO port flash when you dial the DN?  If
you see it flash, then you probably don't have it connected to the Valcom
correctly.  Please paste your router config for the voice port and
dial-peer.


On 10/9/07, Countryman, Edward <Edward.Countryman at provena.org> wrote:
>
>
> Second request on this to the group
>
> When I dial the DAC for the paging port it waits a moment then fast
> busy.
>
> Has anyone done this with a valcom from a cisco FXO port?
>
>
> -----Original Message-----
> From: cisco-voip-bounces at puck.nether.net
> [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Countryman,
> Edward
> Sent: Tuesday, October 09, 2007 11:40 AM
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] Help with Paging interface
>
>
> I've installed an FXO port in my router and believe I have it configured
> correctly in CCM but cannot get it to open when connected to a VALCOM
> V2000A.
>
> When dialing the route pattern for this port; it appears to sit for
> several seconds then go fast busy.  It is almost like it is waiting for
> something from the valcom (dial tone detect?)
>
> I presently have the battery feed switch on the valcom set to ON.
>
> Any ideas?
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20071009/9ab50169/attachment.html