[cisco-voip] 2800 as Data Router & VG - MGCP Bounces Data

Erick Bergquist erickbee at gmail.com
Tue Sep 4 22:36:03 EDT 2007


The SRST testing part tells me it is something in IOS causing a problem.

Are both T1s on the same controller? Can you post the T1 setup?

I have a few on 12.4(11)T2 with data T1 on port 0 and MGCP PRI on port
1 in a 2 port VWIC without issue so far.

On 9/4/07, Carter, Bill <bcarter at sentinel.com> wrote:
>
>
> No, the 1st slot is not configured in CCM.
>
>  ________________________________
>  From: Wes Sisk [mailto:wsisk at cisco.com]
> Sent: Tuesday, September 04, 2007 11:34 AM
> To: Carter, Bill
> Cc: cisco-voip at puck.nether.net
> Subject: Re: [cisco-voip] 2800 as Data Router & VG - MGCP Bounces Data
>
>
> Bill,
>
> Did you configure the first slot in CCM? I'm pretty sure any configured
> endpoint gets shut/no shut during config download.
>
> debug ccm-manager config
>
> /wes
>
> Carter, Bill wrote:
>
> I have a 2821 with 2 vwic2-2mftt1 cards.  The first VWIC supports 2 point to
> point T-1s running MLPPP.  The second VWIC supports 1 voice PRI.  The Voice
> Gateway is running MGCP.  With ccm-config on the gateway, a CallManager
> reset of the Gateway resets the voice AND data ports!
>
> Further complications....I tested SRST by inserting an access-list blocking
> traffic from the 2821 to the CallManagers.  When the gateway went into
> fallback mode, the 2 data T1 ports went out of service!
>
> IOS 12.4(11)T3
>
> Is this normal??  Do I need to switch to H.323?
>
> Thx ________________________________
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>


More information about the cisco-voip mailing list