[cisco-voip] Troubleshooting Inline Power problems on a 3560

[Pennington, Craig]

I have a 3560 that says power granted on ports but does not power the
devices.  I have turned on every debug ilpower option there is but all
it says is a couple of detect cycles then power granted.  I searched
around Cisco's site and all I found is where it says the 6500 series
have some capability to troubleshoot and the other models don't have
much.
 
Any suggestions?  
 
Craig Pennington
Network Engineer
National Collegiate Athletic Association
Office: 317-917-6950
Fax: 317-917-6888
cpennington at ncaa.org <mailto:cpennington at ncaa.org> 
www.ncaa.org <http://www.ncaa.org/> 
 

This email and any attachments may contain confidential and privileged information.  If you are not the intended recipient, please notify the sender immediately by return email, delete this message and destroy any copies.  Any dissemination or use of this information by a person other than the intended recipient is unauthorized and may be illegal.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070905/5b85f7d7/attachment.html