[cisco-voip] Dial-peer for CME and external gateway

omar parihuana omar.parihuana at gmail.com
Fri Sep 7 20:42:40 EDT 2007


Hi to All,

I'm using a CME and one external gateway for outgoing calls, this gateway
only is a H.323 terminal, and all work fine. Rightnow I need configure the
gateway (Cisco 2611XM with E1 Card) for incoming calls, I thought that it
will be easier but unfortunately, so far the conf don´t work...

I put into gateway:

dial-peer voice 500 voip
 destination-pattern 45..
 session target ipv4:192.168.200.45
!
but after, my outgoing calls don't proceed (neither incoming calls). the IP
192.168.200.45 is my CME and 45xx are the internal extensions. The internal
extensions 45xx work fine with CME and can do calls via the gateway (I have
other PRI into CME for regular calls, here all work fine).

Just in case, the external device (a older PBX) provide 4 digits in 45xx
format and it is connected to Gateway via E1. Also all devices Gateway and
CME are in the same LAN.

Pls any suggestions will be appreciate...

Rgds.

-- 
Omar E.P.T
-----------------
Certified Networking Professionals make better Connections!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070907/be73faa0/attachment.html 


More information about the cisco-voip mailing list