[cisco-voip] CCM5: PSTN Dialing

[Ramiz Sardar]

Friends,

I am working on voice setup where I am configuring gateways and CCM5. I have
both PBXs with analog phones and Call manager with IP Phones. Now my fist
phase is working fine scenario you can see below:

phone1---pbx1---router1------router2----pbx2---phone2

pbxs are connected with router with e1 pri and routers are connected with
each other via e1 link. Site1 code is 1000 and site2 code is 2000

site1 config ----
dialpeer 2000 voip
destinationpatern 2000
session target router2 ip

site2 config ----
dialpeer 2000 pots
destination 2000
port 1/0:15
forward digit all

so user dial 2000 and extention of any length after site code, it worked
fine. Means in configuration I am not matching all digits so rest of digits
forward after dialpeer matches. This thing is very useful for pstn dialing
as I don't need the configure multiple dialpeer of different lengths.
Now Issue is that it is not working in the scenario in which I have CCM and
gateway.

IP Phone----CCM-----------Gateway----------PSTN

I configure destination pattern 9 on ccm that pointing to gateway. Then I
configured a dialpeer on Gateway that will forward call to pri with

pstn.
Gateway config ---
Dialpeer voice 9 pots
Destination-pattern 9
port 1/0:15
forward digit all

But it is not working. As I press 9, I get silly tone. Please help me get
this issue resolved
Waiting.....

Best Regards
Rameez
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20080226/c1c25c8e/attachment.html