[cisco-voip] Outbound calls failing 0x80D2 - Identified channel does not exist

[MILLS, Mark]

Hi All,

I am experiencing a problem with outbound calls that I have not seen
before doing a CCM implementation.   When attempting to place a call to
the PSTN, it fails and debug isdn q931 reports the error "0x80D2 -
Identified channel does not exist".  Incoming calls from the PSTN work
correctly.

It's a 3825, currently running the shipped 12.4(13d) IOS and using MGCP
to CallManager 6.  I am using the same config I have used elsewhere that
has worked without any issues.  The config is as follows:


controller E1 0/0/0
 framing CRC4 Australia
 pri-group timeslots 1-31 service mgcp
 description E1 to PSTN
!
interface Serial0/0/0:15
 no ip address
 encapsulation hdlc
 isdn switch-type primary-net5
 isdn incoming-voice voice
 isdn bind-l3 ccm-manager
 isdn bchan-number-order ascending
 no cdp enable
!
voice-port 0/0/0:15
 cptone AU
!

The debug isdn q931 when placing a call is as follows:

---------------------------
Jan  8 18:53:02.819 CDT: ISDN Se0/0/0:15 Q931: TX -> SETUP pd = 8
callref = 0x001A
        Sending Complete
        Bearer Capability i = 0x8090A3
                Standard = CCITT
                Transfer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA9839F
                Exclusive, Channel 31
        Calling Party Number i = 0x0181, 'xxxxxxx'
                Plan:ISDN, Type:Unknown
        Called Party Number i = 0xA1, 'xxxxxxx'
                Plan:ISDN, Type:National
Jan  8 18:53:02.883 CDT: ISDN Se0/0/0:15 Q931: RX <- RELEASE_COMP pd = 8
callref = 0x801A
        Cause i = 0x80D2 - Identified channel does not exist
----------------------------

Any suggestions on what I should be looking at for this issue???

 - Mark
"Warning:
The information contained in this email and any attached files is
confidential to BAE Systems Australia. If you are not the intended
recipient, any use, disclosure or copying of this email or any
attachments is expressly prohibited.  If you have received this email
in error, please notify us immediately. VIRUS: Every care has been
taken to ensure this email and its attachments are virus free,
however, any loss or damage incurred in using this email is not the
sender's responsibility.  It is your responsibility to ensure virus
checks are completed before installing any data sent in this email to
your computer."