[cisco-voip] Power over Ethernet

[Jason Aarons (US)]

Does the router have the correct AC power supply for the NM-16ESW?

 

Did the wiring pass a certification test?

 

A fluke meter would show if voltage is being applied by NM-16ESW, etc.

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Kevin Dunn
Sent: Monday, January 21, 2008 10:22 AM
To: Cisco Voice
Subject: [cisco-voip] Power over Ethernet

 

Okay so this is a newbie question, but I can't seem to find the answer.

 

I have an MGCP Gateway on a 2811 

this is a small 5 person office so they have an Ethernet module on the
router. (NM-16ESW) with a power card (PPWR-DCARD-16ESW).

 

This weekend I tried to cut over the site and I can't get power to the
phones.

 

the Config looks like this:

 

Interface FastEthernet1/1

decription Sue's Phone and PC

switchport access Vlan 4

switchport voice vlan 3

duplex full

speed 100

power inline auto 

mls qos cos override

spanning-tree portfast

 

according to the router my options are power inline (auto, never).  Do I
need cdp enabled on the port to detect the phone?  How do I get power to
the phones?

 

Much appreciated

 

Kevin Dunn  




-----------------------------------------
Disclaimer:

This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only.  If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful.  If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20080121/0afe6fac/attachment-0001.html