[cisco-voip] CME: Ad-Hoc Multiparty Conferencing Problem

[PhilippG]

You need a dedicated DSP for conferencing. Your 2 DSPs are needed for 
voice termination, so there are no more DSPs for conferencing.

Ramiz Sardar wrote:

> CME#sh inventory
> NAME: "2811 chassis", DESCR: "2811 chassis"
> PID: CISCO2811 , VID: V05 , SN: FCZ120872XE
> 
> NAME: "WAN Interface Card - Serial (1T) on Slot 0 SubSlot 0", DESCR: 
> "WAN Interface Card - Serial (1T)"
> PID: WIC-1T= , VID: 1.0, SN: 36242834
> 
> NAME: "VWIC2-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1 on Slot 0 
> SubSlot 1", DESCR: "VWIC2-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - 
> T1/E1"
> PID: VWIC2-1MFT-T1/E1 , VID: V01 , SN: FOC12122L32
> 
> NAME: "2nd generation four port FXO voice interface daughtercard on Slot 
> 0 SubSlot 2", DESCR: "2nd generation four port FXO voice interface 
> daughtercard"
> PID: VIC2-4FXO , VID: V03 , SN: FOC12081UJ3
> 
> NAME: "PVDMII DSP SIMM with one DSP on Slot 0 SubSlot 4", DESCR: "PVDMII 
> DSP SIMM with one DSP"
> PID: PVDM2-16 , VID: V01 , SN: FOC11525U28
> 
> NAME: "PVDMII DSP SIMM with one DSP on Slot 0 SubSlot 5", DESCR: "PVDMII 
> DSP SIMM with one DSP"
> PID: PVDM2-16 , VID: V01 , SN: FOC12085AAK
> 
> NAME: "AIM Service Engine 0", DESCR: "AIM Service Engine"
> PID: AIM-CUE , VID: V03 , SN: FOC12043MQE
> 
> If you think there is any problem with configuration, please write down 
> sample steps for Ad-Hoc Conferencing for more then 3 participants.
> Waiting for immediate response
> 
> Note: i am using CME on cisco 2811 with ios 
> c2800nm-spservicesk9-mz.124-15.T5.