[cisco-voip] cme/PRI newbie question

[Ryan West]

Leslie,

Have you tried removing the connection plar 1700 from dial-peer 1?  You also do not have that ephone-dn configured as dual-line or octo-line (cme 4.3 only).  Another alternative would be a set of hunt lines and if you still wanted line appearance for when someone has seized one of the inbound calls, you could just configure button 2 as an overlay.

As for the PRI, you said it was fractional, are sure the D channel is 23?  As a previous poster mentioned, are you seeing "MULTI_FRAME_ESTABLISHED".  If everything else is correct, then a debug voip ccapi inout should provide you with the incoming called and matching dial peers.

-ryan

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Leslie Meade
Sent: Tuesday, July 08, 2008 12:45 AM
To: Jonathan Charles
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] cme/PRI newbie question

I might of explained it wrong. I have a 4 port FSO with 4 inbound lines that are all 1700.
I have a fractional PRI that has a pilot number of 1700 that is not live, however the DiD's (that no one will use) are live.

Once the go ahead is given the Telco will move the 1700 from the FXO to the PRI as its pilot number. At this time I get fast busy on the PRI DID's. Is this normal or is my config incorrect?



-----Original Message-----
From: Jonathan Charles [mailto:jonvoip at gmail.com]
Sent: Monday, July 07, 2008 9:33 PM
To: Leslie Meade
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] cme/PRI newbie question

Well, they have made the pilot live, but it isn't hunting to the other FXO ports... so, once it is busy, the other calls fail. Open a ticket with telco and tell them they are broken.


Jonathan

On Mon, Jul 7, 2008 at 11:23 PM, Leslie Meade <lmeade at signal.ca> wrote:
> I have a four port FXO card and a new fractional pri. The FXO has a
four
> line over lay of XXX XXXX 1700 that is being ported to my pri as the
pilot
> number.
>
>
>
> My question, when I make an inbound call with one of the new DID's.
The
> phone rings and I get through. But if I try it again with another
phone to
> the same number, while till on the first call I get busy signals. I
have 15
> phones all with have the same config as the one below. I have been
told that
> when the pilot number has been made live I will not have this issue. I
this
> true or am I missing something in my config to allow multiple calls to
the
> same number?
>
> None of the DID's in the PRI will be used only the 1700 (pilot number)
is
> being used for incoming calls.
>
>
>
> Leslie
>
>
>
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>