[cisco-voip] cme/PRI newbie question

[Moataz Mamdouh]

i think as i undesrtand that u have to configure the ANI of an ip phone (1700) to match an inbound dial-peer , as u explained you only have 1 pilot number for all the phones , and you don't get problem in the outbound direction !!!

--- On Tue, 7/8/08, Leslie Meade <lmeade at signal.ca> wrote:
From: Leslie Meade <lmeade at signal.ca>
Subject: [cisco-voip] cme/PRI newbie question
To: cisco-voip at puck.nether.net
Date: Tuesday, July 8, 2008, 12:23 AM




 
 






I have a four port FXO card and
a new fractional pri. The FXO has a four line over lay of XXX XXXX 1700 that is
being ported to my pri as the pilot number. 

   

My question, when I make an
inbound call with one of the new DID’s. The phone rings and I get through.. But
if I try it again with another phone to the same number, while till on the first
call I get busy signals. I have 15 phones all with have the same config as the
one below. I have been told that when the pilot number has been made live I
will not have this issue. I this true or am I missing something in my config to
allow multiple calls to the same number? 

None of the DID’s in the PRI
will be used only the 1700 (pilot number) is being used for incoming calls. 

   

Leslie 

   

   

   



 

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip


      
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080708/c81e0937/attachment-0001.html>