[cisco-voip] cme/PRI newbie question

[Voice Noob]

You can't do DID on FXO / POTS lines. You need an analog trunk.

On Mon, Jul 7, 2008 at 11:23 PM, Leslie Meade <lmeade at signal.ca> wrote:

>  I have a four port FXO card and a new fractional pri. The FXO has a four
> line over lay of XXX XXXX 1700 that is being ported to my pri as the pilot
> number.
>
>
>
> My question, when I make an inbound call with one of the new DID's. The
> phone rings and I get through. But if I try it again with another phone to
> the same number, while till on the first call I get busy signals. I have 15
> phones all with have the same config as the one below. I have been told that
> when the pilot number has been made live I will not have this issue. I this
> true or am I missing something in my config to allow multiple calls to the
> same number?
>
> None of the DID's in the PRI will be used only the 1700 (pilot number) is
> being used for incoming calls.
>
>
>
> Leslie
>
>
>
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080708/4833bc3f/attachment.html>