[cisco-voip] cme/PRI newbie question

[Erick Bergquist]

When you say not live, when you call the 1700 number from outside does
the call come down the PRI or is telco sending it to the old line
still and not the PRI?

Can you post a current debug isdn q931 output and relevant portion of
the configuration showing 1700 assigned to a ephone, num-exp,
translation, etc?

On Tue, Jul 8, 2008 at 8:18 AM, Voice Noob <voicenoob at gmail.com> wrote:
> You can't do DID on FXO / POTS lines. You need an analog trunk.
>
> On Mon, Jul 7, 2008 at 11:23 PM, Leslie Meade <lmeade at signal.ca> wrote:
>>
>> I have a four port FXO card and a new fractional pri. The FXO has a four
>> line over lay of XXX XXXX 1700 that is being ported to my pri as the pilot
>> number.
>>
>>
>>
>> My question, when I make an inbound call with one of the new DID's. The
>> phone rings and I get through. But if I try it again with another phone to
>> the same number, while till on the first call I get busy signals. I have 15
>> phones all with have the same config as the one below. I have been told that
>> when the pilot number has been made live I will not have this issue. I this
>> true or am I missing something in my config to allow multiple calls to the
>> same number?
>>
>> None of the DID's in the PRI will be used only the 1700 (pilot number) is
>> being used for incoming calls.
>>
>>
>>
>> Leslie
>>
>>
>>
>>
>>
>>
>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>