[cisco-voip] Multicasting MOH on 3560

[Craig Staffin]

If memory serves me correctly you need the advanced services image to get
multicast routing.
However you could bring the VLANS back to the router with a trunk port and
anchor the PIM statements there.

Craig

On Wed, Jul 23, 2008 at 2:55 AM, John Botha - I.T <JohnB at jhb.mustek.co.za>
wrote:

>  Hi All
>
> I am having trouble running my music on hold at one of my branches offices
> the branches is to small to install a core switch so I use a Catalyst 3560
> switch 24 port the call manager is in HQ and I have a 2800 voice gateway and
> a Cisco 1800 route connected to HQ
>
> I can receive calls over the wan and the pstn but at the the one office
>  the MOH is not working
>
> I have ip pim dense mode configured at all the other offices under the int
> vlan but those are layer 3 switches and its working fine
>
> any ideas how to get that working on a layer 2 switch
>
> Regards,
> John
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>


-- 
Craig Staffin
Craig at staffin.org
(H) 262-437-7313
(C) 262-613-6003
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080723/fdd5068f/attachment.html>