[cisco-voip] Cisco Channel Usage question

[Joseph Mays]

I don't think so. I'm not familiar with the COR list (I should explain that 
I didn't set this box up), but here's what looks relevant from the config.

!
dial-peer cor custom
!
!
!
dial-peer voice 800 pots
 destination-pattern 1..........
 no digit-strip
 port 1/0:5:0
!
dial-peer voice 8800 pots
 destination-pattern 800.......
 no digit-strip
 port 1/0:5:0
!




----- Original Message ----- 
From: "Wes Sisk" <wsisk at cisco.com>
To: "Joseph Mays" <mays at win.net>
Cc: <cisco-voip at puck.nether.net>
Sent: Wednesday, March 12, 2008 12:16 PM
Subject: Re: [cisco-voip] Cisco Channel Usage question


>I see you have a COR list applied.  Is the incoming peer/outgoing peer 
>permitted by the COR?
>
> /Wes
>
> Joseph Mays wrote:
>> Wes --
>>
>>>  'show dial-plan number 8009466382' on the router to see what you get.
>>> other useful debugs:
>>> debug voip ccapi inout
>>
>> Thanks for the input. I was using debug voip ccapi inout before, but 
>> didn't try it in this latest event. I'll give it a shot. I included the 
>> output of 'show dial-plan number 8009466382' in my initial posting to the 
>> list, but I'll put it in again here --
>>
>> nas01#show dialplan number 8009466382
>> Macro Exp.: 8009466382
>>
>> VoiceEncapPeer8800
>>        peer type = voice, information type = voice,
>>        description = `',
>>        tag = 8800, destination-pattern = `800.......',
>>        answer-address = `', preference=0,
>>        CLID Restriction = None
>>        CLID Network Number = `'
>>        CLID Second Number sent
>>        source carrier-id = `', target carrier-id = `',
>>        source trunk-group-label = `',  target trunk-group-label = `',
>>        numbering Type = `unknown'
>>        group = 8800, Admin state is up, Operation state is up,
>>        incoming called-number = `', connections/maximum = 0/unlimited,
>>        DTMF Relay = disabled,
>>        huntstop = disabled,
>>        in bound application associated: 'DEFAULT'
>>        out bound application associated: ''
>>        dnis-map =
>>        permission :both
>>        incoming COR list:maximum capability
>>        outgoing COR list:minimum requirement
>>        Translation profile (Incoming):
>>        Translation profile (Outgoing):
>>        incoming call blocking:
>>        translation-profile = `'
>>        disconnect-cause = `no-service'
>>        type = pots, prefix = `',
>>        forward-digits default
>>        session-target = `', voice-port = `1/0:5:0',
>>        direct-inward-dial = disabled,
>>        digit_strip = disabled,
>>        register E.164 number with GK = TRUE
>>        fax rate = system,   payload size =  20 bytes
>>
>>        Time elapsed since last clearing of voice call statistics never
>>        Connect Time = 0, Charged Units = 0,
>>        Successful Calls = 2, Failed Calls = 0, Incomplete Calls = 0
>>        Accepted Calls = 0, Refused Calls = 0,
>>        Last Disconnect Cause is "10  ",
>>        Last Disconnect Text is "normal call clearing (16)",
>>        Last Setup Time = 92636869.
>> Matched: 8009466382   Digits: 3
>> Target:
>>
>> nas01#