[cisco-voip] CME 3.0 as a pstn

[Avner Izhar]

Hi,
 
It's hard to tell from what you are specifying, if you need specific answers we will need to look at the configs.
 
In any case a pstn emulator based on a router can be configured by specifying to the router appropriate clocking and network side isdn. Remember that the pstn has to be a voice PRI with dsp and all, just like the client router.
 
------------------------------------------- 
thanks, 
Avner Izhar 
CCIE#15999 (Voice), CCVP, CCSI# 31623 
Technical Training Manager 
CCBOOTCAMP - A Cisco Sponsored Organization (SO) 
Email: aizhar at ccbootcamp.com 
Toll Free: 877-654-2243 
Direct: +1-702-968-5100 = Outside the USA 
FAX: +1-702-446-8012 


   _____  

From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Unni
Sent: Tuesday, May 06, 2008 9:28 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] CME 3.0 as a pstn


Hi all

I would like to use cisco 7960 Installed with CME 3.1 as a pstn switch for my lab setup, but the t1PRI never comes ip as Multiframe established, A(lways on  Awiting establishment state or TEI _Assigned state. Verified the clock settings on 1760 ( Tdm). Then removed the telephony- service completely and try to register it as a MGCP gateway , under int se0/1:23  , ISDN Bind-l3  ccm manager option is not avaolable only optionis isdn bind-l3 Q931, changed the Ios version still no luck . Any one with suggestions
 
thanks
 
unni
 


No virus found in this incoming message.
Checked by AVG.
Version: 7.5.524 / Virus Database: 269.23.9/1418 - Release Date: 5/6/2008 5:17 PM



No virus found in this outgoing message.
Checked by AVG. 
Version: 7.5.524 / Virus Database: 269.23.9/1418 - Release Date: 5/6/2008 5:17 PM
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20080506/c852edfb/attachment.html