[cisco-voip] 911 calls routing out a POTS line via FXO port

[Scott Voll]

each building will need its own CSS.  each building will also need a separte
911 partition.  with a route pattern to 911 that points to the local VGW.

The negitive with this is that if anyone moves between buildings and the CSS
doesn't change.... you still have the same general issue.  (911 goes out the
wrong VGW).

Better solution is either Cisco Emergency Responder or third party E911
solution.  This makes the phone --> 911 dynamic and can go out your defualt
VGW (PRI) and end up at the PSAP correctly with the right Building location.

Hope that all makes sense.

Scott

On Tue, May 13, 2008 at 7:58 AM, Michael Muscat <michaelm at umcu.org> wrote:

> Hello all,
>
> I have 7 buildings and need all calls to 911 to go out a different POTS
> line through the router in each building.  Currently if 911 is dialed it
> goes out our outbound PRI and all calls are showing as originating from
> our Data Center so the police go there instead of where the call is
> actually coming from.  If anyone can help me with either the command to
> input into the router at each location to make 911 calls go out an FXO
> or FXS port, or something to setup on CM 4.1.3 itself, I would really
> appreciate it.  Or if there are any other ways of setting this up.
>
> Thanks a lot,
>
> Michael Muscat
> University of Michigan Credit Union
> michaelm at umcu.org
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20080513/1185e6ab/attachment.html