[cisco-voip] 911 calls routing out a POTS line via FXO port

[Andrew Short]

CER/E911 is decent, and does a few things nothing else will do (central
site screen pops for 911 calls, callback to non-DIDs, ERLs per
switchport, etc) but I've found UC6 and device mobility to be excellent
at routing calls to 911 based on location of the phone.    If you have
UC6 already, you should investigate device mobility.

 

**Please note my new email address:  andrew.short at cdw.com
<mailto:andrew.short at cdw.com> 

--

Andrew Short, CCIE #6641

CDW Berbee

11711 North Meridian Street, Suite 225

Carmel, Indiana  46032

317.569.4222 - office

317.569.4201 - fax

andrew.short at cdw.com

www.berbee.com <http://www.berbee.com/> 

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Scott Voll
Sent: Tuesday, May 13, 2008 11:21 AM
To: Michael Muscat
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] 911 calls routing out a POTS line via FXO port

 

each building will need its own CSS.  each building will also need a
separte 911 partition.  with a route pattern to 911 that points to the
local VGW.  

 

The negitive with this is that if anyone moves between buildings and the
CSS doesn't change.... you still have the same general issue.  (911 goes
out the wrong VGW).

 

Better solution is either Cisco Emergency Responder or third party E911
solution.  This makes the phone --> 911 dynamic and can go out your
defualt VGW (PRI) and end up at the PSAP correctly with the right
Building location.

 

Hope that all makes sense.

 

Scott

On Tue, May 13, 2008 at 7:58 AM, Michael Muscat <michaelm at umcu.org>
wrote:

Hello all,

I have 7 buildings and need all calls to 911 to go out a different POTS
line through the router in each building.  Currently if 911 is dialed it
goes out our outbound PRI and all calls are showing as originating from
our Data Center so the police go there instead of where the call is
actually coming from.  If anyone can help me with either the command to
input into the router at each location to make 911 calls go out an FXO
or FXS port, or something to setup on CM 4.1.3 itself, I would really
appreciate it.  Or if there are any other ways of setting this up.

Thanks a lot,

Michael Muscat
University of Michigan Credit Union
michaelm at umcu.org

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20080513/a5e794ad/attachment.html