[cisco-voip] CCM 4.x MGCP T1 E&M Wink Start

Fri May 16 08:17:44 EDT 2008

so the digits are ascii encoded there 38 = 8, 30 =0, you get the picture.
is this gateway h.323 or mgcp?  if h.323 you will need a dial-peer 
matching the pattern below.
if mgcp you will need that number configured in cm.

/wes

Dustin S. Fowler wrote:
>
> Thank you for your help.
>
>  
>
> Below  is what I received. Can you help me decode? What is the 
> received number?
>
>  
>
> .May 15 22:42:49: htsp_process_event: [0/0/0:1(1), EM_ONHOOK, 
> E_DSP_SIG_1100]em_onhook_offhook
>
> .May 15 22:42:49: htsp_timer - 50 msec
>
> .May 15 22:42:49: htsp_process_event: [0/0/0:1(1), EM_QUALIFY_SEIZURE, 
> E_HTSP_EVENT_TIMER]em_qualify_seizure_timeouthtsp_setup_ind
>
> .May 15 22:42:49: [0/0/0:1(1)] get_local_station_id calling num= 
> calling name= calling time=05/15 22:42  orig called=
>
> .May 15 22:42:49: htsp_timer - 3000 msec
>
> .May 15 22:42:49: htsp_process_event: [0/0/0:1(1), EM_WAIT_SETUP_ACK, 
> E_HTSP_SETUP_ACK]em_wait_setup_ack_get_ack
>
> .May 15 22:42:49: htsp_timer_stop interdigit timer cfgd to 3000
>
> .May 15 22:42:49: htsp_timer2 - 128 msec
>
> .May 15 22:42:49: htsp_process_event: [0/0/0:1(1), EM_WAIT_SETUP_ACK, 
> E_HTSP_EVENT_TIMER2]em_wait_prewink_timer
>
> .May 15 22:42:49: em_offhook (0)vnm_dsp_set_sig_state:[recEive and 
> transMit0/0/0:1(1)] set signal state = 0x8em_onhook 
> (200)vnm_dsp_set_sig_state:[recEive and transMit0/0/0:1(1)] set signal 
> state = 0x0
>
> .May 15 22:42:49: htsp_digit_ready: digit = 38
>
> .May 15 22:42:49: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_VTSP_DIGIT]em_offhook_digit_collect
>
> .May 15 22:42:49: htsp_digit_ready: digit = 30
>
> .May 15 22:42:49: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_VTSP_DIGIT]em_offhook_digit_collect
>
> .May 15 22:42:49: htsp_digit_ready: digit = 30
>
> .May 15 22:42:49: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_VTSP_DIGIT]em_offhook_digit_collect
>
> .May 15 22:42:49: htsp_digit_ready: digit = 36
>
> .May 15 22:42:49: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_VTSP_DIGIT]em_offhook_digit_collect
>
> .May 15 22:42:50: htsp_digit_ready: digit = 35
>
> .May 15 22:42:50: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_VTSP_DIGIT]em_offhook_digit_collect
>
> .May 15 22:42:50: htsp_digit_ready: digit = 32
>
> .May 15 22:42:50: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_VTSP_DIGIT]em_offhook_digit_collect
>
> .May 15 22:42:50: htsp_digit_ready: digit = 35
>
> .May 15 22:42:50: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_VTSP_DIGIT]em_offhook_digit_collect
>
> .May 15 22:42:50: htsp_digit_ready: digit = 36
>
> .May 15 22:42:50: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_VTSP_DIGIT]em_offhook_digit_collect
>
> .May 15 22:42:50: htsp_digit_ready: digit = 32
>
> .May 15 22:42:50: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_VTSP_DIGIT]em_offhook_digit_collect
>
> .May 15 22:42:50: htsp_digit_ready: digit = 36
>
> .May 15 22:42:50: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_VTSP_DIGIT]em_offhook_digit_collect
>
> .May 15 22:42:50: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_HTSP_VOICE_CUT_THROUGH]em_offhook_voice_cut
>
> .May 15 22:42:50: htsp_call_bridged invoked
>
> .May 15 22:42:50: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_HTSP_VOICE_CUT_THROUGH]em_offhook_voice_cut
>
> .May 15 22:42:53: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_DSP_SIG_0000]em_offhook_onhook, HF duration=0
>
> .May 15 22:42:53: mlpp_supported_interface MLPP supported on this trunk
>
> .May 15 22:42:53: mlpp_detection_enabled Preemption detection is not 
> enabled
>
> .May 15 22:42:53: em_start_timer: 0 ms
>
> .May 15 22:42:53: htsp_timer - 0 msec
>
> .May 15 22:42:53: htsp_process_event: [0/0/0:1(1), EM_OFFHOOK, 
> E_HTSP_EVENT_TIMER]em_offhook_wait_release_req
>
> .May 15 22:42:53: htsp_timer_stop
>
> .May 15 22:42:53: htsp_timer_stop2
>
> .May 15 22:42:53: htsp_process_event: [0/0/0:1(1), 
> EM_RLS_WAIT_RLS_REQ, E_HTSP_RELEASE_REQ]em_wait_rls_release em_onhook 
> (0)vnm_dsp_set_sig_state:[recEive and transMit0/0/0:1(1)] set signal 
> state = 0x0
>
> .May 15 22:42:53: em_start_timer: 400 ms
>
> .May 15 22:42:53: htsp_timer - 400 msec
>
> .May 15 22:42:53: htsp_process_event: [0/0/0:1(1), EM_WAIT_CLR_DONE, 
> E_HTSP_EVENT_TIMER]em_clr_done
>
> .May 15 22:42:53: htsp_process_event: [0/0/0:1(1), EM_ONHOOK, 
> E_DSP_SIG_0000]em_onhook_onhook
>
>  
>
> *From:* Nick Griffin [mailto:nick.jon.griffin at gmail.com]
> *Sent:* Thursday, May 15, 2008 10:41 PM
> *To:* Dustin S. Fowler
> *Cc:* cisco-voip at puck.nether.net
> *Subject:* Re: [cisco-voip] CCM 4.x MGCP T1 E&M Wink Start
>
>  
>
> Take a look at "debug vpm signal, and inspect the "DIGIT_COLLECT" 
> section. That should tell you the digits your receiving.
>
> On Thu, May 15, 2008 at 9:30 PM, Dustin S. Fowler 
> <dustin.s.fowler at gmail.com <mailto:dustin.s.fowler at gmail.com>> wrote:
>
> All,
>
>  
>
> I am trying to figure out if a number is coming inbound to a E&M Wink 
> Start T1 configure in MGCP. The 'debug ISDN q931' for the reason that 
> it is not a ISDN PRI.
>
> Any help is welcomed.
>
>  
>
> Semper Fidelis,
>
>  
>
> Dustin
>
>  
>
>  
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net <mailto:cisco-voip at puck.nether.net>
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>  
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>   
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20080516/a5c99a42/attachment.html 