[cisco-voip] Bussy number - Call Cannot be Completed as Dialed

[Mladen Milanovic]

Ryan,

Thanks on your answer. I am sure that we are getting a wrong disconnect
message from carrier. If I confirm that, is there any way that we can
change CCM behavior - to react on this message differently ? 

 

Mladen

 

From: Ryan Ratliff [mailto:rratliff at cisco.com] 
Sent: Thursday, May 29, 2008 10:58 AM
To: Mladen Milanovic
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Bussy number - Call Cannot be Completed as
Dialed

 

The first place to look is a q931 debug at the voice gateway to see what
disconnect cause is being sent back to CM.

 

-Ryan

 

On May 29, 2008, at 10:45 AM, Mladen Milanovic wrote:

 

Guys,

I am connected to Centrex DMS 100 via T1 PRI using primary-ni
signalization. When phone on the Cetrex switch is busy I am getting a
message from the CCM that Call Cannot Be Completed as Dialed. I am using
H.323 as a signaling protocol between CCM 6.0(1a) and VGs

 

Can anyone provide any explanation for this 

 

Thanks

Mladen

_______________________________________________

cisco-voip mailing list

cisco-voip at puck.nether.net

https://puck.nether.net/mailman/listinfo/cisco-voip

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080529/c3b187e3/attachment.html>