[cisco-voip] Polycom Video integrated to Cisco

[Philip Walenta]

To support video through an IOS device requires some unique dial peers.
Have a look at this document:
 
http://www.cisco.com/en/US/docs/ios/12_4t/12_4t11/h320gw.html

  _____  

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Justin Steinberg
Sent: Tuesday, September 02, 2008 8:44 PM
To: cisco-voip
Subject: [cisco-voip] Polycom Video integrated to Cisco


I have a couple of Polycom video units that are currently integrated via PRI
to an Avaya PBX for ISDN access to the PSTN.

C.O.---PRI-----Avaya-------PRI------Polycom (VSX8000)

I am forklifting the Avaya for CUCM. Has anyone used the TDM switching
functionality in the ISR to switch inbound/outbound PSTN ISDN video calls
between pots dial-peers to provide the same functionality on Cisco that is
currently provided by the Avaya PBX?  Any better solution than TDM switching
that works well?

I could always fall back on using an Adtran.  Where the C.O PRIs terminate
to Adtran and the Adtran routes the video DID to the polycom units and
everything else to the CUCM/ISRs.  But I'd rather not use the Adtran if I
can avoid it.

Thanks

Justin

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080903/fee08470/attachment.html>