[cisco-voip] LCR software for VOIP

[Mohit Saxena]

Hello friends,

I want to know your opinion on implementing the LCR software the
Operator level. We have calls going to apparently all the destinations
in the world. We use Cisco Gateway to route all the international calls
to a big carriers. For this we put only one dial peer per carrier. I
want to know if there is a solution for implementing automatic least
cost routing ? secondly, do we need to configure thousand's of dial peer
for implementing it??
How it's done basically on your end.

Your suggestions are welcome.

Brgds,

Mohit



DISCLAIMER: The information contained in this message (including any attachments) is confidential and may be privileged. If you have received it by mistake please notify the sender by return e-mail and permanently delete this message and any attachments from your system. Any form of dissemination, use, review, distribution, printing or copying of this message in whole or in part is strictly prohibited if you are not the intended recipient of this e-mail. Please note that e-mails are susceptible to change. STARCOMMS PLC shall not be liable for the improper or incomplete transmission of the information contained in this communication nor for any delay in its receipt or damage to your system. STARCOMMS PLC does not guarantee that the integrity of this communication has been maintained or that this communication is free of viruses, interceptions or interferences. STARCOMMS PLC reserves the right to monitor all e-mail communications, whether related to the business of STARCOMMS or not, through its internal or external networks.