[cisco-voip] 7906 phones stopped working with CME

[Bill Talley]

Any chance option 150 is no longer being passed by the dhcp server, or is passing the wrong address?   

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Erick Bergquist
Sent: Friday, September 12, 2008 11:24 PM
To: nikola at att.net
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] 7906 phones stopped working with CME

Also, the tftp debug doesn't even show the 7906 phones trying to TFTP files. The phones do get a IP Address then just sit and spin.
Looking more like a RMA situation.

On Fri, Sep 12, 2008 at 5:13 PM, Erick Bergquist <erickbee at gmail.com> wrote:
> So does anyone know what this box with checkmark is, versus the circle?
> Does it mean anything?
>
>
> On Fri, Sep 12, 2008 at 4:58 PM, Nikola Stojsin <nikola at att.net> wrote:
>> I would try replacing the firmware file - I ran into a similar 
>> problem once before, and problem was traced back to (invisible) data corruption...
>>
>> HTH,
>> Nikola
>>
>>
>>
>> ------------------------------
>> Nikola Stojsin
>> PhD CCIE #12888
>> Nikola at att.net
>> (917) 558-1423
>> (917) 591-9382 (fax)
>> ------------------------------
>>
>>
>> -----Original Message-----
>> From: cisco-voip-bounces at puck.nether.net
>> [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Erick 
>> Bergquist
>> Sent: Friday, September 12, 2008 5:55 PM
>> To: ROZA, Ariel
>> Cc: cisco-voip at puck.nether.net
>> Subject: Re: [cisco-voip] 7906 phones stopped working with CME
>>
>> Yep, all that has been there for awhile. These phones were working fine.
>>
>> On Fri, Sep 12, 2008 at 4:36 PM, ROZA, Ariel 
>> <Ariel.ROZA at la.logicalis.com> wrote:
>>> Eric,
>>>
>>>        You must have the phone firmware file on the router´s flash 
>>> memory,
>> and make sure that you have the tftp-server command applied too...
>>>
>>> Regards,
>>>
>>> Ariel
>>>
>>> -----Original Message-----
>>> From: cisco-voip-bounces at puck.nether.net
>> [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Erick 
>> Bergquist
>>> Sent: Viernes, 12 de Septiembre de 2008 06:30 p.m.
>>> To: cisco-voip at puck.nether.net
>>> Subject: [cisco-voip] 7906 phones stopped working with CME
>>>
>>> Hi,
>>>
>>> I have a strange issue, have about 15 7906 model phones on a CME 4.1
>> system and all of sudden all the 7906 phones except 1 no longer 
>> function correctly. They worked fine before. They just keep cycling 
>> trying to do something, if we put a 7911 model phone on same cable, 
>> same switch port, etc it works fine. We've rebooted the CME router 
>> also even and the phone is getting a DHCP address from the DHCP 
>> server and I can ping it briefly as it cycles.
>>>
>>> On the phone itself, you power it on, the lights blink, then after a
>> couple seconds the Cisco logo is displayed on the LCD and in corner 
>> there is square with a checkmark in it on first cycle after a power on.
>>> On subsequent cycles the phone does, it displays logo with a circle 
>>> in
>> corner with a diamond or square in the circle (can't really make it out).
>>>
>>> What is the factory reset procedure for the 7906?
>>> I tried powering it on with holding down # key and then releasing 
>>> when it
>> lights up, then entering the 123456789*#0 sequence but that did not 
>> make any difference and I let it sit for 15 minutes after doing that.
>>> _______________________________________________
>>> cisco-voip mailing list
>>> cisco-voip at puck.nether.net
>>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>>
>
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip



CONFIDENTIALITY NOTICE: This electronic mail transmission (including any accompanying attachments) is intended solely for its authorized recipient(s), and may contain confidential and/or legally privileged information. If you are not an intended recipient, or responsible for delivering some or all of this transmission to an intended recipient, be aware that any review, copying, printing, distribution, use or disclosure of the contents of this message is strictly prohibited. If you have received this electronic mail message in error, please delete it from your system without copying it, and contact sender immediately by Reply e-mail, or by calling 913-307-2300, so that our address records can be corrected.

Although this e-mail and any attachments are believed to be free of any virus or other defect that might negatively affect any computer system into which it is received and opened, it is the responsibility of the recipient to ensure that it is virus free and no responsibility is accepted by the sender for any loss or damage arising in any way in the event that such a virus or defect exists.