[cisco-voip] RCA to RJ-45

[Voice Noob]

Does that work with CUCM 7.X ? 

 

From: Turpin, Mark [mailto:mark.turpin at Calence.com] 
Sent: Tuesday, April 07, 2009 2:49 PM
To: Voice Noob; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] RCA to RJ-45

 

Why not use the moh-usb-audio= which has RCA inputs?

 

--

MARK TURPIN  |  Systems Engineer  |  CCIE 21649 |  Insight Networking |
www.insight.com

t. 314.656.2315   c. 314.277.7948   f. 314.656.2355
<mailto:mark.turpin at insight.com> mark.turpin at insight.com 

 

The information contained in this message and any attachment may contain
privileged or confidential information protected from disclosure. If you are
not the intended recipient, or an employee or agent responsible for
delivering this message to the intended recipient, you are hereby notified
that any review, dissemination, distribution or copying of this information
is strictly prohibited.  If you have received this transmission in error,
please notify the sender immediately by replying to this message and
destroying the original and all copies.  Thank you.

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Voice Noob
Sent: Tuesday, April 07, 2009 2:14 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] RCA to RJ-45

 

I have a customer that wants to stream from satellite radio feed. They say
they have purchased the service to do this. Their old system used an small
RCA type connection. I suppose I need an E&M card to do this but is there an
adaptor or some pin out diagram to convert the RCA connection to an RJ-45
for the E&M card? 

 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090407/a7dbe724/attachment.html>