[cisco-voip] RCA to RJ-45

[Turpin, Mark]

Why not use the moh-usb-audio= which has RCA inputs?

 

--

MARK TURPIN  |  Systems Engineer  |  CCIE 21649 |  Insight Networking |
www.insight.com

t. 314.656.2315   c. 314.277.7948   f. 314.656.2355
mark.turpin at insight.com <mailto:mark.turpin at insight.com>  

 

The information contained in this message and any attachment may contain
privileged or confidential information protected from disclosure. If you
are not the intended recipient, or an employee or agent responsible for
delivering this message to the intended recipient, you are hereby
notified that any review, dissemination, distribution or copying of this
information is strictly prohibited.  If you have received this
transmission in error, please notify the sender immediately by replying
to this message and destroying the original and all copies.  Thank you.

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Voice Noob
Sent: Tuesday, April 07, 2009 2:14 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] RCA to RJ-45

 

I have a customer that wants to stream from satellite radio feed. They
say they have purchased the service to do this. Their old system used an
small RCA type connection. I suppose I need an E&M card to do this but
is there an adaptor or some pin out diagram to convert the RCA
connection to an RJ-45 for the E&M card? 

 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090407/a4118aad/attachment.html>