[cisco-voip] Send out LD code on a PRI

[Voice Noob]

I get a second dial tone after my call has been setup from my gateway so
they need to see them as DTMF after the call is completed. 

-----Original Message-----
From: Ryan Ratliff [mailto:rratliff at cisco.com] 
Sent: Friday, April 10, 2009 10:38 AM
To: Voice Noob
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Send out LD code on a PRI

Do you just need to prefix those 3 digits on every outbound call or  
is the provider expecting them as dtmf after the initial call setup?

If they just want to see those 3 digits at the beginning of the  
called party number the prefix command on the pots dial-peer or in  
CUCM should take care of it.

-Ryan

On Apr 10, 2009, at 10:34 AM, Voice Noob wrote:

I have seen this question posted but with no solution so I am going  
to ask again to see if anyone has a suggestion. I have CUCM 7.0 with  
an H.323 gateway and a PRI. The Telco is looking for a 3 digit code  
for all long distance calls that is then reported on to someone  
internally. I know I can do this in Call Manager but the powers that  
be will not change the requirement for the Telco side even though no  
one has looked at the reports in months. J So I want to add this code  
for all outgoing calls because I am too lazy to reach over to my  
phone and put the 3 digit code in especially when I use Click-to-Call  
or CUPC. I know I can make something in UCCX to do this but my UCCX  
box is only for testing and development and may not be up 100% of the  
time. I would be open to using a TCL script or even Unity Connection  
if someone has an example on how  to do this. I have tried using the  
prefix command but that is not working as expected. Does anyone have  
a solution to adding a 3 digit LD code to an outbound call on a PRI?





_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip