[cisco-voip] PRI/SIP Trunk for Outbound Dialing

[Kelemen Zoltan]

Can't answer all your questions, but you're right on MGCP. MGCP gives 
direct control of the gateway's physical interfaces to call Manager, but 
there is no way to control a SIP trunk on the gateway.

Also don't forget to enable
voip
allow-connections h323 to sip
allow-connections sip to h323

for this to work.

regards,
Zoltan


Matthew Loraditch wrote:
>
> All,
>
> I have someone who wants to do the following.
>
> All Inbound from PRI
>
> Outbound up to 10 calls Via SIP Trunks, outbound after 10 SIP Calls to 
> PRI.
>
> For this kind of config I’m going to have to use H.323 on my Gateway 
> correct? No way to use MGCP, correct?
>
> Has anyone done this before? I’ve read up a bit on the SIP part and it 
> looks like I’d set them to Preference 1 with a max calls equal to the 
> number of trunks purchased? and then the PRI as pref 2?
>
> Thanks in advance!
>
> *Matthew Loraditch*
> 1965 Greenspring Drive
>
> Timonium, MD 21093
> support at heliontechnologies.com <mailto:support at heliontechnologies.com>
> (p) (410) 252-8830
> (F) (443) 541-1593
>
> Visit us at www.heliontechnologies.com 
> <http://www.heliontechnologies.com>
> Support Issue? Email support at heliontechnologies.com 
> <mailto:support at heliontechnologies.com> for fast assistance!
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>