[cisco-voip] CCM 7.x line load control

[Wes Sisk]

cm does has a couple provisions:
1. code yellow - system wide throttling of calls as CM approaches capacity
2. max signaling events per endpoint - there is service parameter to 
control max rate of SCCP messaging to an endpoint

there is no provision to rate limit a specific endpoint on per-call basis.

/wes

On Thursday, August 20, 2009 2:46:54 PM , Paul <asobihoudai at yahoo.com> 
wrote:
> This definitely sounds like a feature request made to Telco but can CCM 7.x perform line load control as defined by the Telecommunications Industry Association (TIA)?
>
> "A network-provided service feature that allows selective denial of call origination to certain lines when excessive demands for service are required of a switching center. "
>
> I understand CCM can do MCID but not a block of a number or set of numbers for a period of time.
>
> I couldn't find any references to this in Cisco's website to this feature if it *is* available.
>
>
>       
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>