[cisco-voip] Cisco Pri -> BRI -> Polycom HDX 8000

Reindl Bernhard Bernhard.Reindl at kapsch.net
Tue Feb 10 02:23:58 EST 2009


Hi Tim

Many Thanks for your help

This guide was solving my problem, now it is working fine...

The problem was that the networks clock select  command and isdn tei-negotiation first-call on the BRI.

best regards

Bernhard

________________________________
Von: smithsonianwa at gmail.com [mailto:smithsonianwa at gmail.com] Im Auftrag von Tim Smith
Gesendet: Donnerstag, 05. Februar 2009 06:12
An: Reindl Bernhard
Cc: cisco-voip at puck.nether.net
Betreff: Re: [cisco-voip] Cisco Pri -> BRI -> Polycom HDX 8000

Hi,

Whats not working?

Have you done a debug isdn q931?

This is the guide you are after
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00804794c6.shtml

On the cisco side.. hardware and clocking is the essential bit. Read the requirements and restrictions carefully.

Once your config is done according to the guide.. the last problem I saw with this.. the provider was not allowing video calls on the PRI. A debug ISDN q931 will show you a cause code for this though.

Cheers,

Tim

On Wed, Feb 4, 2009 at 12:04 AM, Reindl Bernhard <Bernhard.Reindl at kapsch.net<mailto:Bernhard.Reindl at kapsch.net>> wrote:
hi

Maybe someone has experience with Cisco Pri -> BRI -> Polycom HDX 8000

It is no working. I was looking for some config guides but I couldn't find anything.

1050 - 1057 are the numbers for Video Telephony

here is a short quote from my config:


card type e1 0 0
!
no aaa new-model
network-clock-participate wic 0
network-clock-participate wic 1
no network-clock-participate wic 2
!
!
ip cef
!
!
no ip domain lookup
isdn switch-type primary-net5
!
voice-card 0
 no dspfarm
!
!
voice call send-alert
voice rtp send-recv
!
voice service voip
 allow-connections h323 to h323
 fax protocol t38 nse force ls-redundancy 0 hs-redundancy 0 fallback none
 h323
!
!
!
controller E1 0/0/0
 pri-group timeslots 1-31
 description *** E1 Controller PTA Multi ***
!
!
!
interface Serial0/0/0:15
 no ip address
 encapsulation hdlc
 isdn switch-type primary-net5
 isdn overlap-receiving T302 5000
 isdn incoming-voice voice
 isdn negotiate-bchan
 isdn bchan-number-order ascending
 no cdp enable
!
interface BRI0/1/0
 description *** S0-Video ***
 no ip address
 isdn switch-type basic-net3
 isdn overlap-receiving
 isdn protocol-emulate network
 isdn layer1-emulate network
 isdn incoming-voice voice
 isdn send-alerting
 isdn negotiate-bchan
 isdn skipsend-idverify
 line-power
!
interface BRI0/1/1
 description *** S0-Video ***
 no ip address
 isdn switch-type basic-net3
 isdn overlap-receiving
 isdn protocol-emulate network
 isdn layer1-emulate network
 isdn incoming-voice voice
 isdn send-alerting
 isdn negotiate-bchan
 isdn skipsend-idverify
 line-power
!
interface BRI0/2/0
 description *** S0-Video ***
 no ip address
 isdn switch-type basic-net3
 isdn overlap-receiving
 isdn protocol-emulate network
 isdn layer1-emulate network
 isdn incoming-voice voice
 isdn send-alerting
 isdn negotiate-bchan
 isdn skipsend-idverify
 line-power
!
interface BRI0/2/1
 description *** S0-Video ***
 no ip address
 isdn switch-type basic-net3
 isdn overlap-receiving
 isdn protocol-emulate network
 isdn layer1-emulate network
 isdn incoming-voice voice
 isdn send-alerting
 isdn negotiate-bchan
 isdn skipsend-idverify
 line-power
!
ip route 0.0.0.0 0.0.0.0 10.1.19.254
!
!
ip http server
no ip http secure-server
!
!
!
!
control-plane
!
!
!
voice-port 0/0/0:15
 input gain -4
 echo-cancel coverage 32
 playout-delay nominal 0
 cptone AT
!
voice-port 0/1/0
 compand-type a-law
 cptone AT
!
voice-port 0/1/1
 compand-type a-law
 cptone AT
!
voice-port 0/2/0
 compand-type a-law
 cptone AT
!
voice-port 0/2/1
 compand-type a-law
 cptone AT
!
!
dial-peer voice 100 pots
 translation-profile incoming incoming
 destination-pattern 0.T
 progress_ind alert enable 8
 translate-outgoing called 3
 direct-inward-dial
 port 0/0/0:15
!
!
dial-peer voice 1007 voip
 preference 5
 destination-pattern .T
 progress_ind setup enable 3
 session target ipv4:10.1.16.1
 codec g711ulaw
!
dial-peer voice 1008 voip
 preference 1
 destination-pattern .T
 progress_ind setup enable 3
 session target ipv4:10.1.16.2
 codec g711ulaw
!
dial-peer voice 1050 pots
 destination-pattern 1050
 direct-inward-dial
 port 0/1/0
 forward-digits all
!
dial-peer voice 1051 pots
 destination-pattern 1051
 direct-inward-dial
 port 0/1/0
 forward-digits all
!
dial-peer voice 1052 pots
 destination-pattern 1052
 direct-inward-dial
 port 0/1/1
 forward-digits all
!
dial-peer voice 1053 pots
 destination-pattern 1053
 direct-inward-dial
 port 0/1/1
 forward-digits all
!
dial-peer voice 1054 pots
 destination-pattern 1054
 direct-inward-dial
 port 0/2/0
 forward-digits all
!
dial-peer voice 1055 pots
 destination-pattern 1055
 direct-inward-dial
 port 0/2/0
 forward-digits all
!
dial-peer voice 1056 pots
 destination-pattern 1056
 direct-inward-dial
 port 0/2/1
 forward-digits all
!
dial-peer voice 1057 pots
 destination-pattern 1057
 direct-inward-dial
 port 0/2/1
 forward-digits all
!

thx



_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net<mailto:cisco-voip at puck.nether.net>
https://puck.nether.net/mailman/listinfo/cisco-voip


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090210/fa2abc66/attachment.html>


More information about the cisco-voip mailing list