[cisco-voip] 7200VXR as Session Border Controller/CUBE

[chris.flav at yahoo.ca]

:-0. 

http://www.cisco.com/en/US/prod/collateral/voicesw/ps6790/gatecont/ps5640/product_data_sheet09186a00801da698.html

So i am assuming others will second this opinion that CUBE is not offerring SBC-like functionality?

-----Original Message-----
From: Alex Balashov <abalashov at evaristesys.com>

Date: Fri, 13 Feb 2009 17:43:47 
To: Peter Slow<peter.slow at gmail.com>
Cc: <cisco-voip at puck.nether.net>
Subject: Re: [cisco-voip] 7200VXR as Session Border Controller/CUBE


Cisco.com is marketing.

Peter Slow wrote:

> cisco.com disagrees, is there a particular document you were reading
> that indicated that?
> 
> -Peter
> 
> http://www.cisco.com/en/US/products/hw/routers/ps341/index.html
> 
> On Fri, Feb 13, 2009 at 5:31 PM, Alex Balashov
> <abalashov at evaristesys.com> wrote:
>> Among other things, you can't hairpin SIP-to-SIP calls on that platform (as
>> far as I know).
>>
>> Alex Balashov wrote:
>>
>>> A Cisco VFC router is not an SBC.
>>>
>>> chris.flav at yahoo.ca wrote:
>>>
>>>> Hello,
>>>>
>>>> We are looking to deploy a SBC for SIP subscribers and are looking at
>>>> using a 7204VXR.  We are not needing transcoding facilities but simply
>>>> forwarding SIP INVITES and signalling to and from a SIP gateway to
>>>> subscriber endpoints.
>>>>
>>>> The documentation regarding the setup of such a system is terse,
>>>> therefore any pointers to related information or example configs would
>>>> be appreciated.
>>>>
>>>> I have looked at
>>>> http://www.ciscosystems.com/en/US/docs/ios/voice/cube/configuration/guide/12_4t/vb_12_4t_book.html
>>>>  however I am not seeing any info on the following:
>>>>
>>>> - RADIUS authentication of SIP registrations?
>>>> - different SIP gateways based on realms/fqdn?
>>>>
>>>> Does anyone have the most basic snippets required to allow for:
>>>>
>>>> - SIP gateway behind NAT
>>>> =====================
>>>> it has to be more than:
>>>> !
>>>> ip nat sip-sbc
>>>>  proxy [inside.ip.address] 5060 [outside.ip.address] 5060 protocol udp
>>>>  mode allow-flow-around
>>>>  session-timeout 300
>>>>  override address
>>>>
>>>> - RADIUS auth ?
>>>>
>>>> - REGISTER to SIP gateway (proxying?)
>>>>
>>>> Do we need to use the sip-ua for this?
>>>>
>>>>
>>>> Thanks in advance,
>>>>
>>>> C. Flav
>>>> _______________________________________________
>>>> cisco-voip mailing list
>>>> cisco-voip at puck.nether.net
>>>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>>
>>
>> --
>> Alex Balashov
>> Evariste Systems
>> Web    : http://www.evaristesys.com/
>> Tel    : (+1) (678) 954-0670
>> Direct : (+1) (678) 954-0671
>> Mobile : (+1) (678) 237-1775
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>


-- 
Alex Balashov
Evariste Systems
Web    : http://www.evaristesys.com/
Tel    : (+1) (678) 954-0670
Direct : (+1) (678) 954-0671
Mobile : (+1) (678) 237-1775
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip