[cisco-voip] Avaya - CCM v5 Integration

Fri Feb 20 07:41:02 EST 2009

Ahh..

I meant ISO QSIG.. sorry...

Derick Winkworth wrote:
> Hmm..
>
> Just to try it... why don't you enable IOS QSIG on the PRI between the
> gateway and the Avaya. 
>
> Also, I believe you can configure the Avaya to populate the unknown
> number with something.
>
>
>
> Wes Sisk wrote:
>   
>> try changing cm service parameter "Enable Display IE in Codeset 6".
>>
>> /Wes
>>
>>
>>
>> On Thursday, February 19, 2009 5:40:06 PM, James Jung
>> <James.Jung at telecom.co.nz> wrote:
>>     
>>> Thanks for the comments guys.
>>>
>>>  
>>>
>>> Anyone knows about   "   Codeset 6 IE 0x28  i = 'Russel McAuliff'     "
>>> ?
>>>
>>> What does it do?
>>>
>>> Does MGCP support this?  Because with H323 it worked but with mgcp, it
>>> works only if there's calling number present.
>>>
>>> I saw two types.
>>>
>>> 1. Both calling number and name is seen on Q931. Then, Cisco IP phone
>>> displays only calling name.
>>>
>>> 2. No calling number is seen and only calling name is seen on Q931.
>>> Then, Cisco IP phone displays nothing.
>>>
>>> I don't know why calling name is not displayed.
>>>
>>>  
>>>
>>> ________________________________
>>>
>>> From: Jason Aarons (US) [mailto:jason.aarons at us.didata.com] 
>>> Sent: Thursday, 19 February 2009 16:21
>>> To: James Jung; cisco-voip at puck.nether.net
>>> Subject: RE: [cisco-voip] Avaya - CCM v5 Integration
>>>
>>>  
>>>
>>> I believe you need to use QSIG over MGCP.
>>>
>>>  
>>>
>>> From: cisco-voip-bounces at puck.nether.net
>>> [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of James Jung
>>> Sent: Wednesday, February 18, 2009 9:32 PM
>>> To: cisco-voip at puck.nether.net
>>> Subject: [cisco-voip] Avaya - CCM v5 Integration
>>>
>>>  
>>>
>>> Hi, Gurus
>>>
>>>  
>>>
>>> I have a customer who use Avaya G3si V7 and CCM v5.1.3.
>>>
>>> Voice GW is connected to Avaya PBX through PRI-5net. CCM is using MGCP. 
>>>
>>> (( CCM - Voice GW - Avaya - PSTN ))
>>>
>>>  
>>>
>>> The problem is when Avaya phone calls to Cisco IP phones, the calling
>>> name is not displayed on the IP phones.
>>>
>>>  
>>>
>>> Before this, we used H.323 and at that time, the calling name was
>>> displayed on the Cisco IP phones, but after changing to MGCP, nothing is
>>> displayed.
>>>
>>>  
>>>
>>> I'd really appreciate if anyone can help me on this.
>>>
>>>  
>>>
>>>  
>>>
>>> Below is the Q931 debug messages that shows calls from avaya phone to
>>> cisco IP phone.
>>>
>>>  
>>>
>>>  
>>>
>>> Feb 10 14:42:04: ISDN Se0/0/1:15 Q931: RX <- SETUP pd = 8  callref =
>>> 0x2E05 
>>>
>>>         Sending Complete 
>>>
>>>         Bearer Capability i = 0x9090A3 
>>>
>>>                 Standard = CCITT 
>>>
>>>                 Transfer Capability = 3.1kHz Audio 
>>>
>>>                 Transfer Mode = Circuit 
>>>
>>>                 Transfer Rate = 64 kbit/s 
>>>
>>>         Channel ID i = 0xA18385 
>>>
>>>                 Preferred, Channel 5 
>>>
>>>         Progress Ind i = 0x8183 - Origination address is non-ISDN  
>>>
>>>         Called Party Number i = 0x80, '3940' 
>>>
>>>                 Plan:Unknown, Type:Unknown 
>>>
>>>         Locking Shift to Codeset 6 
>>>
>>>         Codeset 6 IE 0x28  i = 'Russel McAuliff'
>>>
>>> Feb 10 14:42:04: ISDN Se0/0/1:15 Q931: TX -> CALL_PROC pd = 8  callref =
>>> 0xAE05 
>>>
>>>         Channel ID i = 0xA98385 
>>>
>>>                 Exclusive, Channel 5
>>>
>>> Feb 10 14:42:04: ISDN Se0/0/1:15 Q931: TX -> ALERTING pd = 8  callref =
>>> 0xAE05 
>>>
>>>         Progress Ind i = 0x8088 - In-band info or appropriate now
>>> available 
>>>
>>> Feb 10 14:42:07: ISDN Se0/0/1:15 Q931: TX -> CONNECT pd = 8  callref =
>>> 0xAE05 
>>>
>>>         Display i = 'Lois Mckay'
>>>
>>> Feb 10 14:42:07: ISDN Se0/0/1:15 Q931: RX <- CONNECT_ACK pd = 8  callref
>>> = 0x2E05
>>>
>>> Feb 10 14:42:19: ISDN Se0/0/1:15 Q931: RX <- DISCONNECT pd = 8  callref
>>> = 0x2E05 
>>>
>>>  
>>>
>>>  
>>>
>>>  
>>>
>>> Feb 10 14:44:37: ISDN Se0/0/1:15 Q931: RX <- SETUP pd = 8  callref =
>>> 0x2E92 
>>>
>>>         Sending Complete 
>>>
>>>         Bearer Capability i = 0x9090A3 
>>>
>>>                 Standard = CCITT 
>>>
>>>                 Transfer Capability = 3.1kHz Audio 
>>>
>>>                 Transfer Mode = Circuit 
>>>
>>>                 Transfer Rate = 64 kbit/s 
>>>
>>>         Channel ID i = 0xA18388 
>>>
>>>                 Preferred, Channel 8 
>>>
>>>         Progress Ind i = 0x8183 - Origination address is non-ISDN  
>>>
>>>         Calling Party Number i = 0xA1, '3095' 
>>>
>>>                 Plan:ISDN, Type:National 
>>>
>>>         Called Party Number i = 0x80, '3940' 
>>>
>>>                 Plan:Unknown, Type:Unknown 
>>>
>>>         Locking Shift to Codeset 6 
>>>
>>>         Codeset 6 IE 0x28  i = 'David Franklin'
>>>
>>> Feb 10 14:44:37: ISDN Se0/0/1:15 Q931: TX -> CALL_PROC pd = 8  callref =
>>> 0xAE92 
>>>
>>>         Channel ID i = 0xA98388 
>>>
>>>                 Exclusive, Channel 8
>>>
>>> Feb 10 14:44:37: ISDN Se0/0/1:15 Q931: TX -> ALERTING pd = 8  callref =
>>> 0xAE92 
>>>
>>>         Progress Ind i = 0x8088 - In-band info or appropriate now
>>> available 
>>>
>>> Feb 10 14:44:38: ISDN Se0/0/1:15 Q931: RX <- CONNECT pd = 8  callref =
>>> 0x81C1 
>>>
>>>         Progress Ind i = 0x8282 - Destination address is non-ISDN  
>>>
>>>         Date/Time i = 0x09020A0E2C 
>>>
>>>                 Date (yr-mm-dd)   = 09-02-10 
>>>
>>>                 Time (hr:mnt:sec) = 14:44:164
>>>
>>> Feb 10 14:44:38: ISDN Se0/0/1:15 Q931: TX -> CONNECT_ACK pd = 8  callref
>>> = 0x01C1
>>>
>>> Feb 10 14:44:57: ISDN Se0/0/1:15 Q931: TX -> CONNECT pd = 8  callref =
>>> 0xAE92
>>>
>>> Feb 10 14:44:57: ISDN Se0/0/1:15 Q931: RX <- CONNECT_ACK pd = 8  callref
>>> = 0x2E92
>>>
>>>  
>>>
>>> Thanks and regards,
>>>
>>> James.
>>>
>>>  
>>>
>>> ________________________________
>>>
>>> Disclaimer: This e-mail communication and any attachments may contain
>>> confidential and privileged information and is for use by the designated
>>> addressee(s) named above only. If you are not the intended addressee,
>>> you are hereby notified that you have received this communication in
>>> error and that any use or reproduction of this email or its contents is
>>> strictly prohibited and may be unlawful. If you have received this
>>> communication in error, please notify us immediately by replying to this
>>> message and deleting it from your computer. Thank you. 
>>>
>>>
>>>   
>>> ------------------------------------------------------------------------
>>>
>>> _______________________________________________
>>> cisco-voip mailing list
>>> cisco-voip at puck.nether.net
>>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>>   
>>>       
>> ------------------------------------------------------------------------
>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>   
>> ------------------------------------------------------------------------
>>
>>
>> No virus found in this incoming message.
>> Checked by AVG - www.avg.com 
>> Version: 8.0.237 / Virus Database: 270.11.1/1961 - Release Date: 02/19/09 18:45:00
>>
>>   
>>     
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.0.237 / Virus Database: 270.11.1/1961 - Release Date: 02/19/09 18:45:00
>
>   