[cisco-voip] question about this config---

[Scott Voll]

Those would only be used in case of MGCP fail over to H323.  So normal
operation would work with your CM config if you have the two ports that have
dial tone configured.  But in the case of a WAN outage you would be correct
that that site would not have dial tone.

Scott

On Tue, Jan 27, 2009 at 7:39 AM, Tim Reimers <treimers at ashevillenc.gov>wrote:

>  I'm looking at this and unless I'm crazy and have forgotten basic dial
> peers functions, this won't do anything...
>
> 1760 outer has four FXO ports. It is running MGCP.
>
> Note the voice ports 0/0 and 0/1 --
> I'm pretty sure from last I physically saw the device, ONLY those two ports
> have any wiring on them.
> Ports 1/0 and 1/1 have NOTHING plugged into their jacks.
>
> So to my way of looking at this, the dial-peers POTS 1000000 and 2000000
> with a destination pattern of 9T are going to try to go out those ports
> with nothing attached?
>
> That HAS to fail, I would think...  right?
>
>
> "
> voice-port 0/0
>  supervisory disconnect dualtone mid-call
>  echo-cancel coverage 32
>  timeouts call-disconnect 5
>  timeouts wait-release 5
>  timing hookflash-out 50
> !
> voice-port 0/1
>  supervisory disconnect dualtone mid-call
>  echo-cancel coverage 32
>  timeouts call-disconnect 5
>  timeouts wait-release 5
>  timing hookflash-out 50
> !
> voice-port 1/0
>  supervisory disconnect dualtone mid-call
>  output attenuation 6
>  timeouts call-disconnect 5
>  timeouts wait-release 5
>  timing hookflash-out 50
> !
> voice-port 1/1
>  supervisory disconnect dualtone mid-call
>  output attenuation 6
>  timeouts call-disconnect 5
>  timeouts wait-release 5
>  timing hookflash-out 50
>
> .
> .
> .
> dial-peer voice 99900 pots
>  service mgcpapp
>  port 0/0
> !
> dial-peer voice 99901 pots
>  service mgcpapp
>  port 0/1
> !
> dial-peer voice 99910 pots
>  service mgcpapp
>  port 1/0
> !
> dial-peer voice 99911 pots
>  service mgcpapp
>  port 1/1
> !
> dial-peer voice 1000000 pots
>  preference 1
>  destination-pattern 9T
>  no digit-strip
>  port 1/0
> !
> dial-peer voice 2000000 pots
>  preference 2
>  destination-pattern 9T
>  no digit-strip
>  port 1/1
> !
> dial-peer voice 2000 voip
>  incoming called-number .
>  dtmf-relay h245-alphanumeric
>  codec g711ulaw
>  no vad
> !
>
>
>
> Tim Reimers
> Systems Analyst II
> Information Technology Services
> City of Asheville
> 70 Court Plaza
> Asheville, NC 28801
> phone - 828-259-5512
> treimers at ashevillenc.gov <timreimers at ashevillenc.gov>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090127/50c5dd32/attachment.html>