[cisco-voip] Calls from analog phone to IP phone

[Paul]

Unless you're strictly bound to using H.323 for these FXS ports, I'd highly recommend you upgrade your IOS to a version that supports SCCP control of your FXS ports (if your current version does not already), and configure them to use SCCP so you can simply register the ports just like any other IP phone. It's a lot easier.




________________________________
From: Shine Joseph <shinejoseph at dodo.com.au>
To: cisco-voip at puck.nether.net
Sent: Monday, June 1, 2009 1:38:05 AM
Subject: [cisco-voip] Calls from analog phone to IP phone


Hi 
Folks,
 
I am 
running a CUCM7 and a H323 gateway with a couple of FXS ports. Have created a 
route pattern for calls to the analog phones connected to the FXS ports on the 
gateway and the calls from IP phones to these analog phones work as expected. 
But, when I try to  call from analog phone to an IP phone, I am getting a 
message from saying the number do not exists. I can see the the calls match the 
incoming and outgoing dial-peers on the gateway. My dial-peers on the gateway as 
follows:
 
dial-peer voice 1 pots
 trunkgroup BRI 1
 description *** Inbound POTS dial peer for incoming PSTN calls 
***
 destination-pattern 0T
 progress_ind alert enable 8
 progress_ind progress enable 8
 progress_ind connect enable 8
 incoming called-number .
 direct-inward-dial
!
dial-peer voice 33582 pots
 description *** Analog line 33582 ***
 destination-pattern 33582
 no digit-strip
 port 0/1/1
!
dial-peer voice 33 voip
 destination-pattern 33500
 session target ipv4:10.10.210.10
 
I think 
very simple needs to be done in the callmanager to get the calls through, but 
cannot work out what should be done.
 
Any 
help  or pointers are much appreciated.
 
Thanks 
in advance,
 
Shine 
Joseph