[cisco-voip] PBX-to-IPPBX calls
Jason Burns
burns.jason at gmail.com
Fri Jun 5 11:07:49 EDT 2009
Cause i = 0x80E018 - Mandatory information element missing
Cause i = 0x80E27D - Message not compatible with call state or not
implemented
Cause i = 0x82E5 - Message not compatible with call state
Those messages indicate to me that you're sending q931 messages that the far
end switch doesn't like, or that youre getting messages that you don't like.
A sure fire indication at the far end isdn switch type is not configured the
same as your local isdn switch type.
If you're set to primary-qsig, are you positive that your provider is also
set to primary-qsig?
This may not be causing the problem you reported below, but I can only fix
the problems I see error messages for, and those errors tell me your switch
type is mismatched.
For the problem with the call disconnect it would be helpful to get relevant
debugs (SIP, Q931) from each device involved.
On Fri, Jun 5, 2009 at 5:47 AM, Ratko Dodevski <rade239 at gmail.com> wrote:
> Thanks for replying,
> PRI switch-type is set as primary-qsig. I should mention that when i make
> phone calls to PSTN or GSM network trough the IPPBX it works just fine, but
> i can't make calls with phones that are registerd with the IPPBX (which i
> think is some Israelian AIRSPAN).
>
>
> Ratko
>
>
> On Fri, Jun 5, 2009 at 4:58 AM, Jason Burns <burns.jason at gmail.com> wrote:
>
>> It sounds like your PRI Switch Type is set incorrectly based on the type
>> of q931 errors you're getting. Is it NI2, 5ESS, DMS100?
>>
>> On Thu, Jun 4, 2009 at 6:30 PM, Ratko Dodevski <rade239 at gmail.com> wrote:
>>
>>> Hi, i have question (obviously :) )
>>> I have big troubles connecting a TDM PBX to a IPPBX through SBC via SIP.
>>> When I do *debug isdn q931 *I keep getting this massages:
>>> Cause i = 0x80E018 - Mandatory information element missing
>>> Cause i = 0x80E27D - Message not compatible with call state or not
>>> implemented
>>> Cause i = 0x82E5 - Message not compatible with call state
>>>
>>> Called number is ringing but when i pick-up it gives me busy dial and if
>>> i hung-up it rings again. On the SBC I can see that after picking router
>>> sends BYE signal with "Bearer capability not implemented" and instantly
>>> sending 2 more invites for call.
>>> I tried with setting bearer-cap Speech and i use the command isdn
>>> incoming-voice voice.
>>>
>>> Tried many combinations... Any ideas ????
>>>
>>> Thanks
>>> --
>>> Ratko
>>>
>>> _______________________________________________
>>> cisco-voip mailing list
>>> cisco-voip at puck.nether.net
>>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>>
>>>
>>
>
>
> --
> Ratko
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090605/389dc307/attachment.html>
More information about the cisco-voip
mailing list