[cisco-voip] PBX-to-IPPBX calls

[David]

Would the customer need to have logging enabled in order to receive output?

David
  ----- Original Message ----- 
  From: Ratko Dodevski 
  To: Ryan Ratliff 
  Cc: cisco-voip at puck.nether.net 
  Sent: Monday, June 08, 2009 6:05 PM
  Subject: Re: [cisco-voip] PBX-to-IPPBX calls


  Hi all;
  I asked the customer to do the debug voip ccapi inout, make some calls and send me the output. And he said that nothing came out. Does it need to be combined with something else, cos this sounds impossible. I'm thinking to delete all the dial peers and make only this two:

  dial-peer voice 1 pots
   destination-pattern 38923141100
   progress_ind setup enable 3
   progress_ind alert enable 8
   port 0/3/0:15
  !
  dial-peer voice 20 voip
   destination-pattern .T
   progress_ind setup enable 3
   progress_ind alert enable 8
   voice-class codec 1
   session protocol sipv2
   session target ipv4:62.220.200.50:5060
   dtmf-relay rtp-nte h245-alphanumeric

  Dial-peer  1 is for incoming calls to the PBX, and all the others are sent to IPPBX via dial-peer 20.

  Suggestions???

  Regards
  Ratko





------------------------------------------------------------------------------


  _______________________________________________
  cisco-voip mailing list
  cisco-voip at puck.nether.net
  https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090608/a6dad7c5/attachment.html>