[cisco-voip] Help with first time VOIP setup.

[Anthony R. Mattke]

Yeah, I think I found what I"m looking for.. but I need to do some more 
research, as my IOS or router isn't supporting what I found..

It shows setting up something such as the following.

!
dial-peer voice 55 pots
service stcapp
port 1/1
!
voice-port 1/1
caller-id enable
!
ephone 10
device-security-mode none
mac-address DA2F.E2B0.0001
type anl
button 1:5
!


I stcapp isn't shown on the service options list, but it lets me enter 
it. Altho when I try ot get the mac address from show stcapp device 
summary -- that command is missing..

Can't seem to find much on the Cisco FN on this topic.. is this a device 
limitation, or is it IOS based?

-Tony


Paul wrote:
> search for fxs sccp controlled or something like that...
> 
> 
> ----- Original Message ----
> From: Anthony R. Mattke <a.mattke at gmail.com>
> To: Paul <asobihoudai at yahoo.com>
> Cc: cisco-voip at puck.nether.net
> Sent: Tuesday, June 16, 2009 10:19:29 PM
> Subject: Re: [cisco-voip] Help with first time VOIP setup.
> 
> I had no clue you could do that. Sorry ! I'll look and see if I find an 
> example of that done.
> 
> Thanks !
> 
> -Tony
> 
> 
> Paul wrote:
>> Then make it an ephone by registering your FXS port using SCCP.
>>
>> It's easier that way...
>>
>>
>> ----- Original Message ----
>> From: Anthony R. Mattke <a.mattke at gmail.com>
>> To: Paul <asobihoudai at yahoo.com>
>> Cc: cisco-voip at puck.nether.net
>> Sent: Tuesday, June 16, 2009 10:12:37 PM
>> Subject: Re: [cisco-voip] Help with first time VOIP setup.
>>
>> One of them isn't an ephone. Its a FXS port using a dial-peer such as..
>>
>> !
>> dial-peer voice 55 pots
>> destination-pattern 55
>> port 1/1
>> !
>>
>> And then a ephone-dn that I want to use the same extension, or make ring at the same time so either can answer the call..
>>
>> Paul wrote:
>>> Use overlay.
>>>
>>> Assign ephone one and two the same extension originating from two separate ephone-DNs and then use overlay to have them both ring.
>>>
>>>
>>> ----- Original Message ----
>>> From: Anthony R. Mattke <a.mattke at gmail.com>
>>> To: cisco-voip at puck.nether.net
>>> Sent: Tuesday, June 16, 2009 6:13:32 PM
>>> Subject: Re: [cisco-voip] Help with first time VOIP setup.
>>>
>>> Ok, so today, I've been attempting to have two phones ring for the same extension.
>>>
>>> I see this is fairly simple if they're both ephones, but what about 1 ephone and 1 pots ? I can't seem to make this work, and I can't find any documentation regarding setting this up.
>>>
>>> -Tony
>>> _______________________________________________
>>> cisco-voip mailing list
>>> cisco-voip at puck.nether.net
>>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>>
>>>
>>>
>>>      
>>
>>      
>>
> 
> 
>       
>