[cisco-voip] About Grandstream HT502 ATA device and usability with CUCM 6.0

[Paul]

I might be wrong but you might be able to see that Cisco documentation if you create a CCO account...






________________________________
From: cem caglayan <cem.caglayan at gmail.com>
To: Phansalkar Nikhil <nsphansa at yahoo.com>
Cc: Paul <asobihoudai at yahoo.com>; cisco-voip at puck.nether.net
Sent: Wednesday, June 17, 2009 4:23:24 AM
Subject: Re: [cisco-voip] About Grandstream HT502 ATA device and usability  with CUCM 6.0

Hi all,

I've managed to update the firmware of the device. I was not able to see the document which Nikhil referred because of privileges. I've found a similiar topic on the net but it describes the Nokia configuration.

http://snippets101.blogspot.com/2008/08/cisco-and-nokia-dual-mode-part-iv-sip.html

is there any possibility that one can send me the original document which Cisco published?

Thanks in Advance.

CEM


On Wed, Jun 17, 2009 at 12:34 AM, Phansalkar Nikhil <nsphansa at yahoo.com> wrote:

Since it uses SIP, you can try adding the ATA as a third party SIP phone to the CUCM.

The CUCM configuration steps are documented at:
http://www.cisco.com/en/US/customer/docs/voice_ip_comm/cucm/admin/6_0_1/ccmcfg/b09sip3p.html

I recently helped somebody add a Linksys PAP2 (which is an ATA) as a SIP endpoint using the above steps and it worked.

Cheers,
Nikhil





________________________________
From: Paul <asobihoudai at yahoo.com>
To: cem caglayan <cem.caglayan at gmail.com>; cisco-voip at puck.nether.net
Sent: Tuesday, June 16, 2009 8:36:33 AM
Subject: Re: [cisco-voip] About Grandstream HT502 ATA device and usability with CUCM 6.0



Did you read the HT502 manual already?
http://tinyurl.com/lyvgb2

Apparently it only supports SIP for signaling.

You can't use CCM TFTP for its firmware so you'll have to upgrade it manually if necessary.

You'll then have to turn it into a SIP UA that can talk to the SIP components under CCM6.


________________________________
From: cem caglayan <cem.caglayan at gmail.com>
To: cisco-voip at puck.nether.net
Sent: Tuesday, June 16, 2009 1:33:50 AM
Subject: [cisco-voip] About Grandstream HT502 ATA device and usability with CUCM 6.0

Hi all,

Here is the deal, i have a grandstream ht502 ATA device
in my hand, is there any way to implement this device to CUCM 6.0 to
make analog phones getting used???

I've googled and could not find any related document.

Help will be appreciated.

Thanks in advance...


      

_______________________________________________
cisco-voip mailing list

cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip