[cisco-voip] Swapping an FXO card for a T1 card in a Cisco Router 2600

[Miller, Steve]

Is there anything special I need to do in order to install an FXO card
into a slot where there is currently a T1 card?  I shut down the router
(a test router), removed the T1 card and installed the FXO, but the
system doesn't seem to recognize it.  Do I need to reprogram something?
I am a total novice at routers.  Any help would be great.  Thanks.
 

Steve Miller
Telecom Engineer
Dickstein Shapiro LLP
1825 Eye Street NW | Washington, DC 20006
Tel (202) 420-3370| Fax (202) 330-5607
MillerS at dicksteinshapiro.com 

 

--------------------------------------------------------
This e-mail message and any attached files are confidential and are intended solely for the use of the addressee(s)
named above. This communication may contain material protected by attorney-client, work product, or other 
privileges. If you are not the intended recipient or person responsible for delivering this confidential
communication to the intended recipient, you have received this communication in error, and any review, use, 
dissemination, forwarding, printing, copying, or other distribution of this e-mail message and any attached files 
is strictly prohibited. Dickstein Shapiro reserves the right to monitor any communication that is created, 
received, or sent on its network.  If you have received this confidential communication in error, please notify the 
sender immediately by reply e-mail message and permanently delete the original message. 

To reply to our email administrator directly, send an email to postmaster at dicksteinshapiro.com

Dickstein Shapiro LLP
http://www.DicksteinShapiro.com

==============================================================================
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090512/e917b280/attachment.html>