[cisco-voip] NM-HDA-FXS or EM-HDA-8FXS

[Paul]

Go0se is correct. Neither of those support DID functionality.




________________________________
From: Go0se <me at go0se.com>
To: "Carter, Bill" <bcarter at sentinel.com>; cisco-voip at puck.nether.net
Sent: Tuesday, May 12, 2009 2:17:23 PM
Subject: Re: [cisco-voip] NM-HDA-FXS or EM-HDA-8FXS


I believe that if they do not
have the “/DID” designation in the card type that they will not support DID
mode. If you have the card(s) in a live router you can verify by attempting to issue
the “signal did {immediate | wink-start | delay-dial}” command on one of the voice
ports.
 
-Go0se
 
From:cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Carter, Bill
Sent: Tuesday, May 12, 2009 10:36 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] NM-HDA-FXS or EM-HDA-8FXS
 
Do either of these support DID lines like the VIC2-4FXS/DID
?