[cisco-voip] Router to Dial POTS line

[Jeff Ruttman]

Greetings,

 

We have an analog line here which I'm setting up for 911 dialing.

 

The line itself works as I can call out with a buttset just fine.  We
have everything configured on the router and in Call Manager.  But it
doesn't work; we get a fast busy.  I want to see if my problem is the
router config or CM, so I'm trying to place a call from the router
thinking that would rule out the router config.

 

I've got the analog line plugged into the 0 port in the FXO card.  I put
"destination-pattern 9T" on the dial-peer as it was part of some example
I found in a cisco doc for dialing out from a router.  The rest of the
configs match a config from another site.

 

voice-port 0/1/0

 timeouts call-disconnect 5

 timeouts wait-release 5

 timing hookflash-out 500

 description 911 Dialing

 

dial-peer voice 999010 pots

 service mgcpapp

 destination-pattern 9T

 port 0/1/0

 

Anyway, I get this when I place a call:

 

Router#csim start 95555555

csim: called number = 95555555, loop count = 1 ping count = 0

 

csim err:csim_do_test invalid major major(16) minor(0)

csim: loop = 1, failed = 0

csim: call attempted = 1, setup failed = 0, tone failed = 0

 

Any insight out there?

 

Thanks

jeff

 

 

CONFIDENTIALITY NOTICE: The information contained in this email including attachments is intended for the specific delivery to and use by the individual(s) to whom it is addressed, and includes information which should be considered as private and confidential. Any review, retransmission, dissemination, or taking of any action in reliance upon this information by anyone other than the intended recipient is prohibited. If you have received this message in error, please reply to the sender immediately and delete the original message and any copy of it from your computer system. Thank you.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090514/c9775ef1/attachment.html>