[cisco-voip] Making QuickVPN Client Work With Pix Firewall

[Scott Voll]

Jim--
What do you currently have?

is that ipsec or PPTP?  what is quickVPN?

you might find this helpful.

http://archives.devshed.com/forums/networking-100/requirements-for-vpn-access-2217099.html

Scott


On Fri, May 29, 2009 at 11:20 AM, Jim Reed <jreed at swiftnews.com> wrote:

>  *Since there are a lot of very, very smart people out there, I'm putting
> this out there to see if any of you latent geniuses have figured this out.
>
> We're trying to make the LinkSys QuickVPN Client work from behind a PIX
> firewall — including 501 and 506E -- that is running PAT.  If we set the
> computer up outside the firewall, it works just fine.  When we put it behind
> the firewall, it indicates it is making a connection and says its applying
> the policy and then hangs on verifying network.
>
> Just wondered if anyone else had tried this and was able to make it work.
>
> We’ve been beating our heads against the wall on this all morning but
> really don’t mind doing that because it feels so good when we quit.
>  However, it’s now getting to the point where it doesn’t feel good when we
> quit!
>
> Thanks in advance, gang...
> *--
> Jim Reed
> Swift Communications, Inc.
> 970-683-5646 (Direct)
> 775-772-7666 (Cell)
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090529/ced8b6c4/attachment.html>