[cisco-voip] Calling Name Issue with Nortel 11c and 61c with QSIG

[Syed Khalid Ali]

There is NO CallManager involved. Just two voice gateways.

On Sun, Nov 1, 2009 at 11:31 PM, Nate VanMaren <VanMarenNP at ldschurch.org>wrote:

>  Is there a Cisco Communications Manager controling the voicegateways?
> H.323 support for QSIG is very very limited, you need to run the gateways
> with MGCP, and you'll get much better results with QSIG.
>
> -Nate
>  ------------------------------
> *From:* cisco-voip-bounces at puck.nether.net [
> cisco-voip-bounces at puck.nether.net] On Behalf Of Syed Khalid Ali [
> syed.khalid.khursheed at gmail.com]
> *Sent:* Sunday, November 01, 2009 1:39 AM
> *To:* cisco-voip at puck.nether.net
> *Subject:* [cisco-voip] Calling Name Issue with Nortel 11c and 61c with
> QSIG
>
>  Greeting:
>
>  I have the following scenario. Two PBXes 11c and 61c. Both connected with
> Cisco Voice gateways as following:
>
> 11c----------------E1----------------VG1----------------VG2----------------61c
> Calls are working fine but I could not able to get the Caller Name at each
> site. Both PBXes are acting the ISDN network side but QSIG.
>
>  11c has extension of 12XX and
> 61c has 2XXX, 3XXX, 4XXX
>
>  After looking at the command reference, I concluded that following
> commands should work:
> isdn supp-service name calling
> isdn outgoing display-ie
>
>  I did the following config on both sides:
>  interface Serial0/3/0:15
>  no ip address
>  no logging event link-status
>  isdn switch-type primary-qsig
>  isdn incoming-voice voice
>  isdn supp-service name calling
>  isdn send-alerting
>  isdn sending-complete
>  isdn outgoing display-ie
>  no cdp enable
>
>  but I am getting the following error message in Q931 debugs:
>  ISDN Se0/3/0:15 Q931: Applying typeplan for sw-type 0x16 is 0x0 0x1,
> Calling num
>  1216
> ISDN Se0/3/0:15 Q931: Applying typeplan for sw-type 0x16 is 0x0 0x9, Called
> num
> 0302
> ISDN Se0/3/0:15 Q931: TX -> SETUP pd = 8  callref = 0x071A
>         Sending Complete
>         Bearer Capability i = 0x8090A3
>                 Standard = CCITT
>                 Transfer Capability = Speech
>                 Transfer Mode = Circuit
>                 Transfer Rate = 64 kbit/s
>         Channel ID i = 0xA9839F
>                 Exclusive, Channel 31
>         Progress Ind i = 0x8183 - Origination address is non-ISDN
>         Calling Party Number i = 0x0180, '1216'
>                 Plan:ISDN, Type:Unknown
>         Called Party Number i = 0x89, '0302'
>                 Plan:Private, Type:Unknown
>         Locking Shift to Codeset 5
>         Codeset 5 IE 0x31  i = 0x80
>         Codeset 5 IE 0x32  i = 0x81
> ISDN Se0/3/0:15 Q931: RX <- CALL_PROC pd = 8  callref = 0x871A
>         Channel ID i = 0xA9839F
>                 Exclusive, Channel 31
> ISDN Se0/3/0:15 Q931: RX <- ALERTING pd = 8  callref = 0x871A
>         Locking Shift to Codeset 5
>         Codeset 5 IE 0x32  i = 0x81
>
>   ISDN Se0/3/0:15 Q931: TX -> DISCONNECT pd = 8  callref = 0x071A
>         Cause i = 0x8090 - Normal call clearing
> ISDN Se0/3/0:15 Q931: RX <- CONNECT pd = 8  callref = 0x871A
>         Progress Ind i = 0x8182 - Destination address is non-ISDN
>         Connected Number i = 0x0080, '4446'
>         Locking Shift to Codeset 5
>         Codeset 5 IE 0x32  i = 0x81
>  ISDN Se0/3/0:15 **ERROR**: Ux_BadMsg: Invalid Message for call state 11,
> call id
>  0x8E1D, call ref 0x71A, event 0x7
> ISDN Se0/3/0:15 Q931: TX -> STATUS pd = 8  callref = 0x071A
>         Cause i = 0x80E507 - Message not compatible with call state
>         Call State i = 0x0B
>  ISDN Se0/3/0:15 Q931: RX <- RELEASE pd = 8  callref = 0x871A
> ISDN Se0/3/0:15 Q931: TX -> RELEASE_COMP pd = 8  callref = 0x071A
>
>  --
> Thanks,
> Syed Khalid Ali
>
>
>
> NOTICE: This email message is for the sole use of the intended recipient(s)
> and may contain confidential and privileged information. Any unauthorized
> review, use, disclosure or distribution is prohibited. If you are not the
> intended recipient, please contact the sender by reply email and destroy all
> copies of the original message.
>
>


-- 
Thanks,
Syed Khalid Ali
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091102/023c0300/attachment.html>