[cisco-voip] Outbound Call parameters?

[Scott Voll]

I don't think there is anything in CM to do this.  with some time and a lot
of energy you could look through CDRs and try and route calls based on past
calling patterns....... But that is not my idea of a good time.

Scott

On Tue, Nov 3, 2009 at 2:17 PM, Madziarczyk, Jonathan <
JMad at cityofevanston.org> wrote:

>  So as I understand it my route group/list is what dictates my outbound
> call gateway distribution.  But what determines how I best use those
> gateways seems to be limited to two algorithms, top down and
> circular…neither of which seem to do what I want….
>
>
>
> We have a new PRI in the mix that gives us a set number of free local
> minutes (36,000).  But the minutes after that are at a slightly higher
> rate.  Is there a way to get CUCM to best utilize the new PRI and it’s free
> minutes?
>
>
>
> I don’t think there’s a way to tell CUCM to “use the first 36,000 minutes
> on PRI A then start using PRI B.
>
>
>
> There doesn’t appear to be a way to even set ratios for gateways.  Like a
> 2:3 ratio for PRI A and PRI B, respectively.  In theory if this ratio was
> similar to my amount of free minutes vs. total minutes I would, over time
> come fairly close to using all the free minutes and as few of the “after
> free, more expensive” minutes.
>
>
>
> Am I missing something, or is this just a limitation of CUCM?
>
>
>
> Even if I have to send all calls to the new PRI I will still save money in
> the long run, but wasting money is still wasting money.
>
>
>
> JonM
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091103/5bbd3ae6/attachment.html>