[cisco-voip] MGCP FXO PLAR??

[Dave Wolgast]

We use UCCE 7.2, which has a solution for remote agents, using analog
phones.

The config requires that ICM use a FXS "phone" as a target, which is
connected directly to a FXO port on a voice gateway.  The IOS config from
the setup doc directs that FXO port to be plar opx <PSTN destination>, then
a pots dial-peer pointing to the outbound PRI.

However, my PSTN gateways are all MGCP (and I'll have to install an FXO vwic
somewhere).

Can I set up the PLAR through MGCP and have the CUCM route the call through
the MGCP-controlled PRI?

If not, can I set up the FXO plar as H.323 and then route it out the MGCP
PRI?

-- 
Dave Wolgast
Livonia, NY
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091106/95f7e70f/attachment.html>