[cisco-voip] Voice Router - PRI Card Compatibility

[Kim, Hyoun S]

ARG..  I had the feeling it was the wrong card... but wanted to verify
with other experts before I raised a hullabaloo.

 

Thanks Mike.

 

P.S. - How do I know if a DSP was included in my bundle?

 

Hyoun Kim

Network Administrator I

Charter Media - East Division

640 Broadmor Blvd, Suite 80

Murfreesboro, TN 37129

 

Email: Hyoun.Kim at chartercom.com

Office: 615.217.6245

Fax: 615.217.6255

 

From: Norton, Mike [mailto:mikenorton at pwsd76.ab.ca] 
Sent: Monday, November 16, 2009 4:41 PM
To: Kim, Hyoun S; cisco-voip at puck.nether.net
Subject: RE: Voice Router - PRI Card Compatibility

 

HWIC is for data, not voice. As for whether or not they shipped you the
wrong card, that depends on what you ordered. ;-)

 

Don't forget you will need DSP as well, unless the router was purchased
as a bundle that came with it.

 

-- 

Mike Norton

I.T. Support

Peace Wapiti School Division No. 76

Helpdesk: 780-831-3080

Direct: 780-831-3076

 

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Kim, Hyoun S
Sent: November-16-09 3:21 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Voice Router - PRI Card Compatibility

 

I'm not too keen on my VoIP terminology, so please excuse me if you get
confused... 

My company recently purchased a C2811 router for a VoIP deployment at a
branch office. Currently they are using PRI to connect to their analog
(Avaya) phone system. I am to remove their analog system entirely and
replace it with a Cisco VoIP solution. 

While I have never actually installed a Cisco VoIP system from scratch,
I have maintained the one at my current office. I have most of the
configuration finished on the router, but I cannot specify the voice
ports on the new C2811 router. The PRI that is used at the remote office
is the same type that is used in my current office.

After a couple hours of troubleshooting, I came to the realization that
the card that is currently in use at my office is a "VWIC2-2MFT-T1/E1".
The card that came with my voice router for the remote branch is a
"HWIC-1DSU-T1". Is this the reason why I cannot configure my voice
ports? Did they ship me the wrong card?

 

Thanks in advance.

 

 

 

________________________________

Hyoun Kim * Network Administrator I - East Division

640 Broadmor Blvd * Suite 80 * Murfreesboro, TN 37129

' 615.217.6245 * ' 859.312.6941 * 7 615.217.6255 * * 
Hyoun.Kim at chartercom.com

 

 
E-MAIL CONFIDENTIALITY NOTICE: 
 
 
 
 
 
 
 
The contents of this e-mail message and 
any attachments are intended solely for the 
addressee(s) and may contain confidential 
and/or legally privileged information. If you 
are not the intended recipient of this message 
or if this message has been addressed to you 
in error, please immediately alert the sender
 by reply e-mail and then delete this message 
and any attachments. If you are not the 
intended recipient, you are notified that 
any use, dissemination, distribution, copying, 
or storage of this message or any attachment 
is strictly prohibited.
 
 
 
 
 
 
 

E-MAIL CONFIDENTIALITY NOTICE: 

 

 

 

The contents of this e-mail message and 
any attachments are intended solely for the 
addressee(s) and may contain confidential 
and/or legally privileged information. If you 
are not the intended recipient of this message 
or if this message has been addressed to you 
in error, please immediately alert the sender
 by reply e-mail and then delete this message 
and any attachments. If you are not the 
intended recipient, you are notified that 
any use, dissemination, distribution, copying, 
or storage of this message or any attachment 
is strictly prohibited.







-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091116/64d1efe5/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/jpeg
Size: 1990 bytes
Desc: image001.jpg
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091116/64d1efe5/attachment.jpe>