[cisco-voip] E1 Card and Voice ports 3845

[CCIETalk.com]

Yeah if your controllers don't show up then try card-type.

On 11/18/09, Cumhur Kizilari <yahoo at cumhur.com> wrote:
> Dear Martin,
>
> Have you tried  "card type e1" command ?
>
> Best Regards.
> Cumhur KIZILARI
>
>>
>>
>> On Wed, Nov 18, 2009 at 4:34 PM, CCIETalk.com <ccietalk at gmail.com> wrote:
>>
>>> Did you configure your controller E1?
>>>
>>> On 11/18/09, Martin Bufton <m.bufton at spectra-group.co.uk> wrote:
>>> > Good afternoon.
>>> >
>>> >
>>> >
>>> > I need help with a PRI card, please.
>>> >
>>> >
>>> >
>>> > It is installed in a Cisco 3845 running C3845-SPServicesK9-M 12.4
>>> > (15)T9
>>> >
>>> > The card is a VWIC2-2MFT-T1/E1 installed in HWIC0
>>> >
>>> > I plan to use this as a MGCP gateway.
>>> >
>>> >
>>> >
>>> > I'm expecting to see the voice-ports in the configuration. but the
>>> running
>>> > configure doesn't show anything about the presence of the card.
>>> >
>>> >
>>> >
>>> > Show version reports "2 channelized (E1 or T1)/PRI ports"
>>> >
>>> >
>>> >
>>> > Thanks in advance
>>> >
>>> >
>>> >
>>> >
>>>
>>> --
>>> Sent from my mobile device
>>>
>>> www.ccietalk.com
>>> _______________________________________________
>>> cisco-voip mailing list
>>> cisco-voip at puck.nether.net
>>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>>
>>
>>
>

-- 
Sent from my mobile device

www.ccietalk.com