[cisco-voip] Mobile Connect SNR problem

[Jamie Weatherhead]

Afternoon all,

 

I am running CUCM 6.1(3) and have configured mobile connect. I have
setup a remote destination profile and remote destination to point to my
mobile (cell) phone.

 

I can get my IP phone and mobile to ring simultaneously. However, when I
take the incoming call on my mobile and disconnect, I'm not able to
continue the call on my IP phone. If I attempt to pickup the connected
line I get a 'no conference bridge' message.

 

I am dialling out of a h323 gateway and have followed Cisco's
configuration notes. I have also tried multiple mobile phone service
providers but to no avail.

 

Is there any configuration work I need to do on the voice gateway?

 

Any assistance would be appreciated. 

 

Jamie Weatherhead

 


Consider the environment - Think before you print

The contents of this email are confidential to the intended recipient and may not be disclosed. Although it is believed that this email and any attachments are virus free, it is the responsibility of the recipient to confirm this. 

You are advised that urgent, time-sensitive communications should not be sent by email. We hereby give you notice that a delivery receipt does not constitute acknowledgement or receipt by the intended recipient(s).

Details of Charles Stanley group companies and their regulators (where applicable), can be found at this URL http://www.charles-stanley.co.uk/contact-us/disclosure/

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091123/b11d9ba2/attachment.html>