[cisco-voip] New PRI card

[Ccie]

You need to put in
Card type t1 0 0
Or equivalent for e1

Sent from my iPhone

On Sep 15, 2009, at 14:46, "Norton, Mike" <mikenorton at pwsd76.ab.ca>  
wrote:

> If your new card is one of the ones that can do both T1 and E1, then  
> you have to tell it which you want it to be before any of the usual  
> commands will be accepted. Don’t remember the exact command to do th 
> at off the top of my head, but I do remember struggling through that 
>  the first time I used one of those cards.
>
>
>
> --
>
> Mike Norton
>
> I.T. Support
>
> Peace Wapiti School Division No. 76
>
> Helpdesk: 780-831-3080
>
> Direct: 780-831-3076
>
>
>
> From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net 
> ] On Behalf Of Ratko Dodevski
> Sent: September-15-09 1:40 PM
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] New PRI card
>
>
>
> Hi all,
> in sh run i get this card type command needed for slot/vwic-slot  
> 0/0. I guess I need to enter network-clock-participate wic 0 to  
> enable the new PRI card, but it doesn't accept the command. What am  
> I doing wrong. The only network-clock-participate is wic 1 and that  
> is the BRI card.
>
> Thanks
> Regards
>
> -- 
> Ratko
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090915/2fe2a21a/attachment.html>