[cisco-voip] PRI Trunk Group H323

Sun Sep 20 08:38:58 EDT 2009

For the archive's

Is it possible to create a trunk group for PRI (Digital) Ports. Do share
your config snippet with which you got it working.

Aman

On Sat, Sep 12, 2009 at 12:47 AM, RAWLE GORDON <ragordon at mtb.com> wrote:

> Thank you guys ......
> This is really great information. Thought I was losing it, you all were
> saying yes, I was seeing no ..... All participants are correct including me.
> The trunk group definition can be placed on the serial interface (Dchannel).
> I had been trying different things in an effort to get a group programmed
> and on the controller in question that I was working with, I had placed a
> trunk group label. That label kept the "trunkgroup" parameter from showing
> up as an option for the interface. I just didn't realize that this behavior
> (no option presented) would be the result.
>
> Thanks for all your help ......
> It's great to have this type of support out there in cyberspace. Have a
> great weekend all .....
>
> Tony G
>
>
> >>> Jonathan Charles <jonvoip at gmail.com> 9/11/2009 12:55 PM >>>
>  The command is there, it just returns an error when you enter it.
>
> J
>
> On Fri, Sep 11, 2009 at 11:44 AM, Nate VanMaren
> <VanMarenNP at ldschurch.org> wrote:
> > On PRI I think you go into the serial interface not the voice port.
> > CHQVG001(config)#int s0/0/0:23
> > CHQVG001(config-if)#trunk-group ?
> >  WORD  Trunk group label
> >
> > -Nate
> > -----Original Message-----
> > From: Jonathan Charles [mailto:jonvoip at gmail.com]
> > Sent: Friday, September 11, 2009 10:22 AM
> > To: Nate VanMaren
> > Cc: RAWLE GORDON; cisco-voip at puck.nether.net
> > Subject: Re: [cisco-voip] PRI Trunk Group H323
> >
> > HQ(config-voiceport)#trunk-group PRI
> >  Error: Failed to add non-analog port to trunk group
> >  Configure in cas-custom mode or serial interface
> >  mode for T1/E1 digital ports and in BRI interface
> >  mode for BRI voice ports
> > HQ(config-voiceport)#
> >
> >
> >
> > Jonathan
> >
> > On Fri, Sep 11, 2009 at 11:16 AM, Nate VanMaren
> > <VanMarenNP at ldschurch.org> wrote:
> >> These are from c3845-advipservicesk9-mz.124-11.XW3.bin, but I have
> another that is c3845-spservicesk9-mz.124-22.T1.bin, that is the same.
> >>
> >> The annoying thing about trunk groups is there is 3 different syntaxes
> depending on the spot in ios
> >>
> >> trunk group  InteCom  (defines the trunk group in global)
> >> trunk-group InteCom 10 (on the voice port, or serial int)
> >> trunkgroup InteCom (on the dial peer)
> >>
> >> -Nate
> >>
> >>
> >> -----Original Message-----
> >> From: RAWLE GORDON [mailto:ragordon at mtb.com]
> >> Sent: Friday, September 11, 2009 10:12 AM
> >> To: Jonathan Charles; Nate VanMaren
> >> Cc: cisco-voip at puck.nether.net
> >> Subject: RE: [cisco-voip] PRI Trunk Group H323
> >>
> >> Nate,
> >> This option at the serial interface (Dchannel) for "trunk-group" is not
> available in IOS 12.4(20)X. What IOS is associated with these snips ?
> >>
> >> TG
> >>
> >>>>> Nate VanMaren <VanMarenNP at ldschurch.org> 9/11/2009 12:07 PM >>>
> >> Nah, it's just the same as analog.
> >>
> >> Here's a few snips of config and a show command.
> >>
> >> trunk group  InteCom
> >>  hunt-scheme sequential
> >>
> >> interface Serial0/0/0:23
> >>  trunk-group InteCom 10
> >>
> >> interface Serial0/0/1:23
> >>  trunk-group InteCom 11.
> >>
> >> dial-peer voice 10 pots
> >>  trunkgroup InteCom
> >>  description InteCom PRIs Outbound
> >>  translation-profile outgoing ToInteCom
> >>  destination-pattern 0#*T
> >>
> >>
> >>
> >> CHQVG001#sh trunk group InteCom
> >> Trunk group: InteCom
> >>        Description:
> >>        trunk group label: InteCom
> >>
> >>        Translation profile (Incoming):
> >>        Translation profile (Outgoing):
> >>
> >>        Preemption is disabled
> >>
> >>        Hunt Scheme is sequential
> >>        Max Calls (Incoming):   NOT-SET (Any)   NOT-SET (Voice) NOT-SET
> (Data)
> >>        Max Calls (Outgoing):   NOT-SET (Any)   NOT-SET (Voice) NOT-SET
> (Data)
> >>        Max Calls (MixTotal):   NOT-SET (Any)   NOT-SET (Voice) NOT-SET
> (Data)
> >>        Retries: 0
> >>
> >>        Trunk Se0/0/0:23        Preference 10
> >>                Member Timeslots : 1-24
> >>                Total channels available : 23
> >>                Data = 0, Voice = 2, Modem = 0, Pending = 0, Free = 21
> >>        Trunk Se0/0/1:23        Preference 11
> >>                Member Timeslots : 1-24
> >>                Total channels available : 23
> >>                Data = 0, Voice = 18, Modem = 0, Pending = 0, Free = 5
> >>        Trunk Se0/1/0:23        Preference 12
> >>                Member Timeslots : 1-24
> >>                Total channels available : 23
> >>                Data = 0, Voice = 20, Modem = 0, Pending = 0, Free = 3
> >>        Trunk Se0/1/1:23        Preference 13
> >>                Member Timeslots : 1-24
> >>                Total channels available : 23
> >>                Data = 0, Voice = 22, Modem = 0, Pending = 0, Free = 1
> >>        Trunk Se0/2/0:23        Preference 14
> >>                Member Timeslots : 1-24
> >>                Total channels available : 23
> >>                Data = 0, Voice = 22, Modem = 0, Pending = 0, Free = 1
> >>        Trunk Se0/2/1:23        Preference 15
> >>                Member Timeslots : 1-24
> >>                Total channels available : 23
> >>                Data = 0, Voice = 19, Modem = 0, Pending = 0, Free = 4
> >>
> >>        Total calls for trunk group: Data = 0, Voice = 103, Modem = 0
> >>                                     Pend = 0, Free = 35
> >>
> >>        advertise_flag 0x00000040, capacity timer 25 sec
> tripl_config_mask 0x00000000
> >>        AC_curr 29, FD_curr 80, SD_curr -40
> >>
> >>        succ_curr 1397 tot_curr 1498
> >>        succ_report 1397 tot_report 1498
> >>        changed 1 replacement position 0
> >>
> >>
> >> -----Original Message-----
> >> From: cisco-voip-bounces at puck.nether.net [mailto:
> cisco-voip-bounces at puck.nether.net] On Behalf Of Jonathan Charles
> >> Sent: Friday, September 11, 2009 9:51 AM
> >> To: RAWLE GORDON
> >> Cc: cisco-voip at puck.nether.net
> >> Subject: Re: [cisco-voip] PRI Trunk Group H323
> >>
> >> The trunk group is for analog only...
> >>
> >> You will need to duplicate your peers and create preferences for
> each....
> >>
> >> This way you don't have glare and you can order your outgoing calls to
> >> the last PRI in the telco trunk group.
> >>
> >>
> >> Jonathan
> >>
> >>
> >>
> >> On Fri, Sep 11, 2009 at 10:45 AM, RAWLE GORDON <ragordon at mtb.com>
> wrote:
> >>> Hi there,
> >>> I'm looking for any information on configuring more that a single PRI,
> in a 28XX or 38XX using the H323 protocol. I'm able to locate configuration
> for FXOs but not PRI that works anyway. My router/gateway IOS is 12.4 (20)
> T2. Is this even doable ?
> >>>
> >>> Any assistance/thoughts would be much appreciated .....
> >>>
> >>> Thanks in advance,
> >>> Tony Gordon
> >>> Voice Communications
> >>> M&T Bank
> >>> 410-347-6010
> >>>
> >>>
> >>>
> >>> ************************************
> >>> This email may contain privileged and/or confidential information that
> is intended solely for the use of the addressee.  If you are not the
> intended recipient or entity, you are strictly prohibited from disclosing,
> copying, distributing or using any of the information contained in the
> transmission.  If you received this communication in error, please contact
> the sender immediately and destroy the material in its entirety, whether
> electronic or hard copy.  This communication may contain nonpublic personal
> information about consumers subject to the restrictions of the
> Gramm-Leach-Bliley Act and the Sarbanes-Oxley Act.  You may not directly or
> indirectly reuse or disclose such information for any purpose other than to
> provide the services for which you are receiving the information.
> >>> There are risks associated with the use of electronic transmission.
>  The sender of this information does not control the method of transmittal
> or service providers and assumes no duty or obligation for the security,
> receipt, or third party interception of this transmission.
> >>> ************************************
> >>>
> >>>
> >>> _______________________________________________
> >>> cisco-voip mailing list
> >>> cisco-voip at puck.nether.net
> >>> https://puck.nether.net/mailman/listinfo/cisco-voip
> >>>
> >> _______________________________________________
> >> cisco-voip mailing list
> >> cisco-voip at puck.nether.net
> >> https://puck.nether.net/mailman/listinfo/cisco-voip
> >>
> >>
> >>  NOTICE: This email message is for the sole use of the intended
> recipient(s) and may contain confidential and privileged information. Any
> unauthorized review, use, disclosure or distribution is prohibited. If you
> are not the intended recipient, please contact the sender by reply email and
> destroy all copies of the original message.
> >>
> >>
> >>
> >> ************************************
> >> This email may contain privileged and/or confidential information that
> is intended solely for the use of the addressee.  If you are not the
> intended recipient or entity, you are strictly prohibited from disclosing,
> copying, distributing or using any of the information contained in the
> transmission.  If you received this communication in error, please contact
> the sender immediately and destroy the material in its entirety, whether
> electronic or hard copy.  This communication may contain nonpublic personal
> information about consumers subject to the restrictions of the
> Gramm-Leach-Bliley Act and the Sarbanes-Oxley Act.  You may not directly or
> indirectly reuse or disclose such information for any purpose other than to
> provide the services for which you are receiving the information.
> >> There are risks associated with the use of electronic transmission.  The
> sender of this information does not control the method of transmittal or
> service providers and assumes no duty or obligation for the security,
> receipt, or third party interception of this transmission.
> >> ************************************
> >>
> >>
> >>
> >
>
> ************************************
> This email may contain privileged and/or confidential information that is
> intended solely for the use of the addressee.  If you are not the intended
> recipient or entity, you are strictly prohibited from disclosing, copying,
> distributing or using any of the information contained in the transmission.
>  If you received this communication in error, please contact the sender
> immediately and destroy the material in its entirety, whether electronic or
> hard copy.  This communication may contain nonpublic personal information
> about consumers subject to the restrictions of the Gramm-Leach-Bliley Act
> and the Sarbanes-Oxley Act.  You may not directly or indirectly reuse or
> disclose such information for any purpose other than to provide the services
> for which you are receiving the information.
> There are risks associated with the use of electronic transmission.  The
> sender of this information does not control the method of transmittal or
> service providers and assumes no duty or obligation for the security,
> receipt, or third party interception of this transmission.
> ************************************
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090920/edeb9493/attachment.html>