[cisco-voip] SRST with FXO ports??

[Countryman, Edward]

Thank you for the doc;  Could it be as simple as missing the “DESTINATION-PATTERN XXXX” command???

 

From: Lelio Fulgenzi [mailto:lelio at uoguelph.ca] 
Sent: Tuesday, April 20, 2010 3:07 PM
To: Countryman, Edward
Cc: Cisco-Voip-Puck
Subject: Re: [cisco-voip] SRST with FXO ports??

 

you've got yourself a case of TSD there my friend. (two-stage dialing)

you need need to configure PLAR on those ports so it goes to your auto-attendant.

http://www.cisco.com/en/US/tech/tk652/tk698/technologies_tech_note09186a00800e00d0.shtml

---
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Cooking with unix is easy. You just sed it and forget it. 
                              - LFJ (with apologies to Mr. Popeil)


----- Original Message -----
From: "Edward Countryman" <Edward.Countryman at provena.org>
To: "Cisco-Voip-Puck" <cisco-voip at puck.nether.net>
Sent: Tuesday, April 20, 2010 3:57:42 PM GMT -05:00 US/Canada Eastern
Subject: [cisco-voip] SRST with FXO ports??




Looking for direction on a config issue, I cant seem to put my finger on the problem

 

I have a site with a 2811 (MGCP) with 4-POTS lines connected to a VIC2-4FXO card.

 

Outbound calling from the site in SRST mode works just fine, but when I call into one of the POTS lines while in SRST mode the router answers with a dial tone instead of ringing the default internal extension # 1120.  What am I missing??

 

dial-peer voice 10 pots

   trunkgroup 1

   answer-address 1120

 

 

 


_______________________________________________ cisco-voip mailing list cisco-voip at puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-voip 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100420/347bf6bd/attachment.html>